I have a bunch of the Applight lights (I know I am the only one) and have been experimenting with doing my own lights with pixels and controllers. I had a bad couple of LEDS on one of my applights and decided to rip open the controller box and see if I can run them through my ESP8266 NodeMcu running WLED controller. Looking at the picture, there are 5 wires coming out of controller. 2 are going to each light, soldered into pin D0 and VD+ on the controller, the other 3 are gong directly to the end of string, two to supply power to another string, one into the last LED light. if I was to try and get this controlled by WLED, I see I would use wire in D0 for data, but what would I do with power, use VD+. How may the applights be grounded if each LED does not have VD-. I can get around electronics but get confused on the grounding still learning the pixel wiring. Any help would be appreciated.
I think you're going to have to get out the meter and measure voltages when it's running. Those LEDs work only with a + and - voltage, and if they're normal pixels, there's going to be a data line as well. Open up that plug that shows the LED inside and look at the wires that connect to it. Are there 2, 3 or 4 wires connecting to it? The LED used in a pixel configuration would likely have 4-wires for RGB and V+ if it is a common anode or RGB and -V if it's a common cathode. If it has 3 wires, it could be a WS2812 pixel that has the pixel chip embedded inside the LED.
Others are much more skilled than I at messing with pixels, but you'll need to provide some concrete voltage and polarity measurements in addition to the descriptive information on products that are non-standard for other DIYers to chime in and offer to help.
Good luck. And happy new year!
Thanks for the info. the second photo does show only 2 wires are going to the LED and 2 wires coming out to the next LED. Those wires where I cut are pinned to D0 and VD+ on the controller board. The 3 wires grouped together are definitely just power to the end of the string, as 2 of the 3 goes all the way to the end to a female plug, and the other one to the last LED light on the string. I will open a LED but since its waterproof I'll have to cut it out and see how its wired inside of the LED, but it only has 2 wires to each LED. So if its possible to control a LED product with only 2 wires I would like to to try. I thought since I had a few bad LEDs, I would experiment and hope these lights are some sort of pixel based, since I can change a different color of each LED, although only though the mobile app and it's pre-programmed light shows.
Sorry everyone, I did find another thread on this site discussing hacking these lights and they say they are not useable with other controllers, especially if the LED's are 2 wires.
http://doityourselfchristmas.com/forums/showthread.php?46642-Gemmy-App-Lights-hack
Thanks everyone, I did find an old post that says these 2 wire lights are not hackable.
http://doityourselfchristmas.com/forums/showthread.php?46642-Gemmy-App-Lights-hack


