How to implement 10...
 
Notifications
Clear all

How to implement 100 null pixels?

68 Posts
11 Users
0 Reactions
10.8 K Views
Posts: 1420
Topic starter
(@1pet2-9)
Noble Member
Joined: 6 years ago

I know. Any reason not to just tie OE to gnd?


Reply
Posts: 105
(@pakeonoahu)
Estimable Member
Joined: 11 years ago
packetbob wrote:Can you (or BarnabyBear) post a link to the code for the 74HC125 version?
This is one of those thing that you may never need but can be a life saver when you need it....
Possibly not for Xmas displays but for other types of pixel light display installations...
Especially when one party does the pixel and wiring install and another supplies the controller and the requirement that the pixels be in a single string doesn't get spelled out....
And the pixel wiring is not really accessible to fix...

I will post his code if he didn't get to it and if okay by him, I am testing some issues I found, I believed it was my breadboard getting interferences, when there are pixels connected to the first output (A, 4Y), everything works well for B and C(2Y, 3Y) output, if I removed pixels from A, output B and C pixels flickering and has random colors, mainly doing chase sequences to count the pixels it splits and rainbow to test the colors. It can't be the code because those output ports are isolated, I am going to redo it on another breadboard that are not from Aliexpress, perhaps I will put a scope on it when I have time.

update: the Arduino nano 5v out is causing the issue and I am using 5V pixel for testing, perhaps the Vin(5V) was too low for the regulator(5V LDO?), tie the 74HC125 VCC to 5V power vs using the Arduino 5V out fixed the problem.


Reply
Posts: 105
(@pakeonoahu)
Estimable Member
Joined: 11 years ago
1pet2_9 wrote:I know. Don't you just drive an always-zero?

Not for 2Y and 3Y out, that is to control how many pixels it splits, their OE are tied to D9/D10 on the nano.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Per the spec, the WS2811 chips require >3.5V on their inputs to guarantee that they adequately sense the '1' signal. So generally the driver chip needs to be powered by 5V (not 3.3V).

The other thing to watch for is that the 74AC and 74HC chips have the same requirement on their inputs when they're powered by 5V to guarantee proper operation, so it's better to use the similar 74ACT/74HCT parts in their place. Neither the 3.3V nor the 5V Arduino's are guaranteed to drive their output signals high enough to guarantee proper 74AC/74HC operation as far as I can tell, so I would tell others to use 74ACT parts (the 74AC/74HC parts may appear to work, but there is no guarantee that this will continue over all temperature, power and noise conditions).


Reply
Posts: 1420
Topic starter
(@1pet2-9)
Noble Member
Joined: 6 years ago

If you use a 5V Arduino Uno and power it through the barrel plug with >=7.5V, that should guarantee the output signals are a full 5V. It's when you power through the USB that the 5V hits a voltage drop. I hit that problem when trying to TX/RX RF.


Reply
Page 12 / 14
Share: