K-State Fan wrote:There is a good presentation on ausie Christmas forum on using LOR controllers in DMX mode. I started to but felt it was better to ...
LOR can also be run in DMX mode. I guess I'll figure out the how on that later. I just scanned the manual and didn't see anything about DMX mode. ...
brettjm wrote:I am running a 16 channel LOR controller and an E682 with vixen 3 and it works perfectly. The only thing I had to do is run a cross ove...
Davor wrote:Also, there are various factors that makes either the E682 or E6804 able to send longer distances. So you really have to just test it to b...
510 fixed the problem. 🙂
duramadmax wrote:Pi Needs to be the same as Vixen @510. there is your issue. It will shift all pixels after that by 2 colors (channels) When you say...
K-State Fan wrote:When you cycle thru the colors using the FPP is the last pixel on for all three colors? or is it just on for one of the colors? Do...
I'll have to wait till noon to post it. Is the export list in text format? I thought xseq was binary. Oh wait, when I export, there are two files c...
I got FPP installed. The RPI is currently working, running FPP, with eth0 attached to my router, and my e682 controller board is also attached to the...
Tegbert wrote: Says there you need a usb memory stick. If I am not mistaken the sd card is the operating system and the stick hold sequencing info an...
Macrosill wrote:The flash drive error message is referring to a usb stick. The installer will make new directories and write some files to the usb st...
Got a problem installing FPP. I did everything in the instructions on the FPP site but I get to a point where it says the mounted flash drive isn't f...
