I'm by no means an expert, but this scares me: "I should replace my 5A fuses with 10A" --> NO! The fuses are meant to protect the components, not give...
MikeSD wrote:Hey AuburnLights, I have a house in Auburn, Wa. That's where my project is going to be setup. Small world. Look for the "12" on the fr...
Hey AuburnLights, I have a house in Auburn, Wa. That's where my project is going to be setup. Small world.
Ok, I think I have it now. 😉 I was reading the wiki and it gave an example. Each controller has a unique IP but that's for configuration, with mult...
It's beginning to make sense now. I'll have to look tonight but I think in Vixen, when I specify Multicast for my controller type, I can or should be...
algerdes wrote:A single e682 in multicast mode can handle 7 universes of 510 channels. This is a total of 3570 channels. Since each pixel requires 3 ...
Three answers but none are helping me understand this. So, I'll keep it simple, with a trivial example/question. 1) Can 3 e682 control 3 x 1190 = 35...
Skunberg wrote:The poor English and lots of copy paste makes these sites more of a guide than fact and Ray's is better than most. So two options, one ...
budude wrote:You do *not* count null pixels at the sequencer level - - that's really the whole point of having them as 'null' vs a plain 'ol unused pi...
budude wrote: I'd suggest you put the LOR stuff on it's own universe and start at channel #1 and up to the number of channels you have up to the maxim...
budude wrote:You can run your LOR HW from the E682 directly. It supports an RS485/DMX output so you can run a Cat5 directly from the E682 to your LOR ...
