I'm having trouble wrapping my head around this universe, E1.31 crap. 🙂
The e682 is advertised as 7 universe x 170 RGB pixles, for 1190 pixels, using MultiCast. I have also read something about multicast now using 12, so I'm not sure if that means 2040, using multicast, or if I have to switch to unicast?
Then, I have read something about adding extra boards don't give more pixels, necessarily. I would have expected that 3 e682, on different IP, using the same universe number would still give 3 times the pixels, because the IP is different. Does it or doesn't it?
1) How many RGB Pixels does three (3) e682 controllers control?
2) How many universe can the e682 control, with the latest firmware? Using Multicast? Using Unicast?
3) Since I know what I want, which is to use 3 e682 controllers, what is the best configuration, to maximize the number of RGB pixels using 3 boards?
4) Is there a good website that explains the multicast vs unicast, AND the mapping of universes to boards, so that I can understand how to address RGB pixels using 3 boards?
Thanks,
1/2 - Multicast - 7 universe of 170 pixels (1190), Unicast - 12 universe of 170 pixels (2040) - the E682's are independent from each other. With multicast you *can* run the same traffic to each using identical universe numbers but that's not very common unless you have identical elements. For unicast they would normally be different traffic and while you could reuse the universe, there's no real reason to do that and will just get you confused.
If you are wanting to have enough pixels to support 3 E682s I would run them all in unicast. That way each controller and universe is addressed separately. In all my research so far it says that small displays can use multicast and have virtually no problems. But larger displays will have lots of problems. Just google unicast vs multicast. There should also be some good info on here about the major differences.
If you can keep the show network away from your home network (preferably WIRED as well), then you can use either multicast or unicast with no issues at all. Multicast is a bit easier to setup but yes - you do lose 5 universe of control. When you mix in multicast on some home routers it can cause issues in some cases especially if you are streaming video, etc to your TVs, etc.
Three answers but none are helping me understand this. So, I'll keep it simple, with a trivial example/question.
1) Can 3 e682 control 3 x 1190 = 3570 RGP lights, separately and independently? (i.e. can I control each light, one only at a time, if I wanted to. Just for question purpose)
2) If it can, can it be done in Multicast? OR do I have to switch to unicast?
3) If it can't, then would unicast give me 3 x 2040 = 6120
4) Is there a tutorial explanation on addressing so that I can understand the difference between unicast and multicast and pixel addressing?
I understand a universe is 170 RGB pixels. And I understand multicast with e682 is 7 universe, which limits number of pixels per board.
But since each board can have it's own IP, I'd assume I can control more lights, independently, by assigning different IP, so communications would be handled only by the board with the matching IP. Right or Wrong? What am I missing?
