Good tip but that's not the problem. I have a 0 to 24:00 set until 2099. And it's enabled. It's not 00:00 to 24:00 but rather 00:00 to 23:59. Coul...
One last thing before I call it an evening. It looks like it might be working. I have an issue with the PI and FPP though. I seem to have to start...
I'm not sure of anything at this point. But it's pretty straight forward. 6 strings of 150 RGB, and 360 dummy channels, to fill up 6 universes. The...
Almost there. Still one issue. I can control my RGB lights, and now my LOR stuff, from Vixen. Everything is working great. However, after I expor...
Wow! Not sure why but when I put the LOR on a logical 2nd controller in Vixen, it started working. Everything is the same as before but I just remove...
I might try that 2nd controller. Something weird is going on in Vixen. My e682 can control the output everytime by using the test. And it does it ap...
deonb wrote:What is the LOR unit id of your LOR1602WG3? If it's anything other than 1, the addressing is off. It is set to d001. From the LOR pane...
I think I have everything straight, except the part about making it work with Vixen 🙂 * I have a cat5-B cable and configured the wiring like this: ...
My controller will be setup to use Multicast (which I think limits me to 7 universes and 1190 pixels). I plan to use 6 strings of 150 pixels, and use...
deonb wrote:If you also want to connect the ground (pin 6) you'll need to use either Green or Orange. See here for which one: I agree with 'budude' ...
I'm from WA too, and confused. Maybe it's a WA thing. 🙂 This is exactly what I have to do. I have a e682 system, for my RGB pixels. This year, I ...
budude wrote:Do you have a free cluster (4 connector group) available on your E682? You can use one of those ports to run your LOR/DMX stuff and not u...
jchuchla wrote:It's hard to get much more specific than just the performance comment. It's related to how the newer version of the Microsoft .net fram...
