MikeSD
@mikesd
Estimable Member
Joined: Dec 11, 2014
Topics: 20 / Replies: 62
Topic
Replies: 20
Views: 10645
Topic
Reply
RE: e682 with Vixen - Quick Start Guide

Tested the lights last night, after fixing my "Start" location in the Controller setup and everything works perfectly. 300 pixels no problem. Two st...

12 years ago
Reply
RE: e682 with Vixen - Quick Start Guide

shanicus wrote:In your above pictured setup window from Vixen, your are telling the software to output the same channel data to all your active univer...

12 years ago
Reply
RE: e682 with Vixen - Quick Start Guide

Still working on this Vixen problem. I have my controller setup like in the last screenshot in the post above, with connector 2-1 on universe 3. My ...

12 years ago
Reply
RE: e682 with Vixen - Quick Start Guide

shanicus wrote:Mike, Each of these pieces of software will allow you to run simple test patterns on your connected hardware but also allow for control...

12 years ago
Reply
RE: e682 with Vixen - Quick Start Guide

Yep! And all 300 run as expected. When I do the default test, the bright pixel moves through all 300 pixels, leaving a dim pixel as it moves on, jus...

12 years ago
Reply
RE: e682 with Vixen - Quick Start Guide

One other thing. I created a preview display and my sequence plays ok. So, for some reason, it's just not being transmitted to the e682 properly. I...

12 years ago
Reply
RE: e682 with Vixen - Quick Start Guide

Art wrote:On the size it should be as many channels as you want on universe 1 up to 510, then add 510 on universe 2 start at 511 that will give you up...

12 years ago
Reply
RE: e682 with Vixen - Quick Start Guide

Art wrote:A picture of your setup display in vixen might help also are you using one e682 or two One controller, using 1 connector only (1-1) I c...

12 years ago
Reply
RE: e682 with Vixen - Quick Start Guide

Art wrote:Each LED =3 pixel for instance in your pic it shows 3 LEDs thats 9 pixels, so if you count 100 LEDs = 300 pixels as far as how many pixel p...

12 years ago
Reply
RE: Anyone know anything about the NEWSTYLE pixel strips

Problem Resolved: :thup: I sent an email to SanDevices about any possible issue with the controllers and he suggested updating the firmware and choos...

12 years ago
Reply
RE: Anyone know anything about the NEWSTYLE pixel strips

I'm running out of things to try. Just verified the order of pins. It's correct. DI (Green, top on strip), 5V (Red, center), Gnd (Black, bottom). ...

12 years ago
Reply
RE: Anyone know anything about the NEWSTYLE pixel strips

I'm wondering if this is relevant to my problem. The description for the product says 130 different changing patterns and changing speeds If every...

12 years ago
Reply
RE: Anyone know anything about the NEWSTYLE pixel strips

kingofkya wrote:Hum another thing to check are you sure your feeding data from the correct end? Already verified that. Data is coming in, from the ...

12 years ago
Page 5 / 6