I'm not sure if my terminology is correct. I don't mean the "controller" for lights. I mean as a replacement for a PC.
I have a couple of Raspberry Pi computers that I used for some radio projects. They both have a version of Linux on them. I know people have used the Pi computer to send 1.31 data to the light controllers. But I don't know if they wrote their own programs or if there are programs readily available to deal with this.
Questions:
1) Does software exist to allow development of sequences on the Pi? Software name?
2) Can sequences be developed in Vixen, LOR S3, other, and then software, resident on the Pi, be used to send it to the controllers? How?
3) If neither of these (1 or 2) are possible, I must be asking the wrong question. In that case, what is the method used to send program data to controllers, using the Raspberry Pi?
I'd like to give this a try this weekend, if I can figure out the necessary parts to this project. I have software for a PC, a couple of PI running Linux, and an e682 controller. For this weekend project, I'd like to be able to:
1) create a simple sequence
2) use the PI to send it to my controller
I'm just missing the "how"
http://falconchristmas.com/forum/index.php/board,8.0.html
Go 🙂 Falcon Player, many folks are using it solely to run their show!
Tory
pi is awsome on my show ,, it controlle all my ligh and music ,,, cheer
Agreed, falcon pi player/FPP is great. This is my second year using it. If they haven't yet, they're at least planning to add the xlights sequence conversion tool to it. That'll allow you to convert sequences without using an additional tool first.
Sequencing everything in Vixen 3, exporting to .fseq files and letting FPP run the show from my Pi B+. Love the setup!!!
pmscientist wrote:Agreed, falcon pi player/FPP is great. This is my second year using it. If they haven't yet, they're at least planning to add the xlights sequence conversion tool to it. That'll allow you to convert sequences without using an additional tool first.
Yep Xlights will convert multiple formats to the FPP required .fseq format.
If you are already familiar with the Pi it should be a breeze to set up start blinking with it.
Once it installs and boots, find the web gui ip address, and its pretty intuitive after that.
They FPP guys have done some great work.
It's only a little bit of extra work to convert and upload the files to the FPP but you will be glad you did - it's the way to go!
sporadic wrote:Sequencing everything in Vixen 3, exporting to .fseq files and letting FPP run the show from my Pi B+. Love the setup!!!
I'm basically using the same setup. I sequenced everything in Vixen 3, exported to fseq files, and FPP runs the show. In my setup, the FPP connects to an Arduino RF bridge that accepts Renard data from the FPP via the USB serial connection. This RF data is then transmitted to my Arduino Light Controllers that are placed throughout the display. For next year, I plan to mount the Raspberry PI, my Arduino based RF bridge, and my FM transmitter in an enclosure together and have my entire "command center" self contained. FPP is definitely the way to go!
Keith
I am also using the PI as my show computer. Ultra stable and no issue with com ports.
Got a problem installing FPP. I did everything in the instructions on the FPP site but I get to a point where it says the mounted flash drive isn't found, please insert. But there is obviously a flash drive there, because that's where the install files are located.
Suggestions? I did place a post on the FPP site about this.
