Activity
 
Notifications
Clear all
Jakadia
@jakadia
Active Member
Joined: May 11, 2021
Topics: 2 / Replies: 7
Reply
RE: Soffit Mounting

mikeh65 wrote:For my permanent mounting on my house. I used J-Channel and drilled holes - 3" spacing. Bullets for the pixels and mounted the channel...

5 years ago
Reply
RE: Soffit Mounting

MikeKrebs wrote:I would go back against the wall at that distance. IMO, You got it figured out correctly. The reassurance is helpful. I think having...

5 years ago
Reply
RE: Soffit Mounting

puppycrack wrote:Vinyl J-Channel could work, and no holes needed. I am planning on using the design found in this thread by uzelessknowledge: You ...

5 years ago
Reply
RE: Soffit Mounting

DrNeutron wrote:No need to drill holes.... You could design a clip that snaps in between the soffit and hold a piece of coduit. Easy to take down and ...

5 years ago
Topic
5 years ago
Replies: 10
Views: 4568
Reply
RE: WLED and Pixel Layout

Awesome. When you say a bufferer chip would that be just a pixel I would use to boost the data signal? Do they make something just for that or would...

5 years ago
Reply
RE: WLED and Pixel Layout

MartinMueller2003 If I understand correctly, I keep my controller close to the first pixel and then after that the distance between pixels aren’t as...

5 years ago
Reply
RE: WLED and Pixel Layout

MartinMueller2003 Not sure on the exact number but around 550 - I think I am going to be at about a pixel every 3”.

5 years ago
Topic
Replies: 9
Views: 3900
Share: