WLED and Pixel Layo...
 
Notifications
Clear all

WLED and Pixel Layout

10 Posts
4 Users
0 Reactions
3,903 Views
Posts: 9
Topic starter
(@jakadia)
Active Member
Joined: 6 years ago
[#54336]

I am looking for some advice on where I should mount my WLED esp controller. I am using all 12v WS2812 pixels and will have adequate power injection sites. Just not sure if I should have 1 controller or 2 in my configuration, if I use 1 where would be the best place to put it to minimize data wire length.

Thanks in advance,
First Time Poster - Jake

Sent from my iPhone using Tapatalk


9 Replies
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Distance is nice but how many pixels are you driving?


Reply
Posts: 9
Topic starter
(@jakadia)
Active Member
Joined: 6 years ago

MartinMueller2003

Not sure on the exact number but around 550 - I think I am going to be at about a pixel every 3”.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

That is well within single string length. Put it where you are standing in the picture so you can get to it. Run an ethernet cable with data buffer from the end of the front garage string up to the left or right end on the back garage. Dont forget to power inject


Reply
Posts: 9
Topic starter
(@jakadia)
Active Member
Joined: 6 years ago

MartinMueller2003

If I understand correctly, I keep my controller close to the first pixel and then after that the distance between pixels aren’t as critical correct?

I plan to inject 12v in 3 spots (every 30-40ft). Maybe middle of long 64’ run, once again between 34’ and 40’ run and at the beginning.

That sound about right? Thanks again for the help by the way.

Jake

Sent from my iPhone using Tapatalk


Reply
Page 1 / 2
Share: