Notifications
Clear all

Soffit Mounting

11 Posts
5 Users
0 Reactions
4,567 Views
Posts: 9
Topic starter
(@jakadia)
Active Member
Joined: 6 years ago
[#54404]

Hey guys,

Attached is a picture of the trim I am going to use to mount my pixels on my shed. Would you suggest mounting them like in the picture right up against the shed or would it make more sense to bring them out to the edge of the soffit like where the question mark is?

I will drill holes every 2-3 inches in the trim and the pixels will be pointing down. I think I am wanting the more “washed” lighting look because I am about 1500ft off the road and I am not sure people will be able to make out any detailed lighting effects.

Let me know your thoughts!

Thanks
Jake

Sent from my iPhone using Tapatalk


10 Replies
DrNeutron
Posts: 2016
(@drneutron)
Noble Member
Joined: 14 years ago

No need to drill holes....
You could design a clip that snaps in between the soffit and hold a piece of coduit. Easy to take down and put up.
I made one a while ago to fit mine and it worked great.

clip

Print in PETG and it is flexible to just bend into place and hold weight fine.


Reply
Posts: 106
(@puppycrack)
Estimable Member
Joined: 6 years ago

Vinyl J-Channel could work, and no holes needed. I am planning on using the design found in this thread by uzelessknowledge:

http://doityourselfchristmas.com/forums/showthread.php?44402-ws2811-mounting

You could use it in either of the two scenarios you show.

-pc


Reply
Posts: 9
Topic starter
(@jakadia)
Active Member
Joined: 6 years ago
DrNeutron wrote:No need to drill holes....
You could design a clip that snaps in between the soffit and hold a piece of coduit. Easy to take down and put up.
I made one a while ago to fit mine and it worked great.

Print in PETG and it is flexible to just bend into place and hold weight fine.

Thought of something similar but I am going for more of a permanent install, similar to like jellyfish lighting.

Jake

Sent from my iPhone using Tapatalk


Reply
Posts: 9
Topic starter
(@jakadia)
Active Member
Joined: 6 years ago
puppycrack wrote:Vinyl J-Channel could work, and no holes needed. I am planning on using the design found in this thread by uzelessknowledge:

http://doityourselfchristmas.com/forums/showthread.php?44402-ws2811-mounting

You could use it in either of the two scenarios you show.

-pc

I already have my pixels bought and I tried a standard piece of J channel which was to shallow to cover the wiring if I wanted to direct my lights down. The piece I had bent up is basically J channel with a 1.5”x1.5” channel for the wiring and lights. I am able to pick the color that best matches my soffit color as well. 10.6’ was $17. The price would go down if I had multiple pieces made.

Sent from my iPhone using Tapatalk


Reply
Page 1 / 3
Share: