Except I've had 4 pixels out of 300 go bad in a real short period lol. When I do the upper roof line, I'm going to do the one that has a backup data c...
I'm guessing I got a bad set of lights. After replacing the first line, things were working again except for like 15 at the end of the 300. I started ...
So I plugged in a brand new line and that was fine. Pulled out every single pixel out of the j channel and placed the new line in. The second line now...
One detail I forget to mention is I have 2 power injection points in 300 lights. If it was a bad v+ or v- wouldn't the power injection help recover it...
Looks like a bread board would be useful to see if this could be programmed after restoring power to it. Maybe I could get it to work before smashing ...
angus40 wrote:To get around the 5-3.3v regulator , did you test powering the board with 3.3v on the 3.3v pin ? I don't have anything to provide 3.3v...
It was a dead voltage regulator on the 3.3v side. It was reading .13v. Thank you Shelby for having me check with a multimeter. A new one is going to b...
seems the WeMos board has issues. Can't believe esPixelStick uses these.
Problem is the WeMos D1 doesn't have a reset pin according to the pinout diagram. I'm assuming high and low is referring to 3v 5v pins?
When the WeMos module is plugged into the board where the power goes in and out the blue light doesn't come on at all anymore. This new WeMos module s...
Nodemcu firmware programmer shows waiting Mac. I think at this point they just need to send me a new one. This is crazy
No sd card installed.
The link I posted is exactly what it is. Trying to upload from my phone fails.
