Dead esPixelStick?
 
Notifications
Clear all

Dead esPixelStick?

49 Posts
6 Users
0 Reactions
6,170 Views
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
JackOfManyMasterOfSome wrote:Problem is the WeMos D1 doesn't have a reset pin according to the pinout diagram. I'm assuming high and low is referring to 3v 5v pins?

High would be 3.3v and low is gnd


Reply
Posts: 28
Topic starter
(@jackofmanymasterofsome)
Eminent Member
Joined: 5 years ago

https://youtu.be/yQd1ZhD4Np4 seems the WeMos board has issues. Can't believe esPixelStick uses these.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
JackOfManyMasterOfSome wrote: https://youtu.be/yQd1ZhD4Np4 seems the WeMos board has issues. Can't believe esPixelStick uses these.

Though rare , issues can happen with all these modules . There hasn't been mass reports of folks having or going through what you are dealing with here vs the volume of EspixelSticks that are out there .

The Esp pro mini will most likely work as a replacement should the need arise .


Reply
sporadic
Posts: 1199
(@sporadic)
Noble Member
Joined: 14 years ago
swanny wrote:Try removing your SD card if you have one. I’m having some issues with 4.0 firmware where the pixels won’t boot well. Currently I’m under the belief it’s the SD card but don’t have a spare EsPixelStick to validate that yet. ( Spares are supposed to be delivered Saturday so the that’s when I’ll spend some time doing diagnostics )

Sent from my iPhone using Tapatalk

That's the first I've heard of that. What's the model and size of the SD card? Make sure it's formatted as FAT32.

JackOfManyMasterOfSome wrote: https://youtu.be/yQd1ZhD4Np4 seems the WeMos board has issues. Can't believe esPixelStick uses these.

I can assure you it's not a mass issue with the board as the failure rate has been less than 1%. I believe you are the same person that emailed me as well? I just responded if so, will include it here.

The blue light is actually connected to the data line so it only lights up when configured to output data or when flashing the firmware. The 3.2 firmware configures the output by default so it will turn on. The 4.0 beta does not. Do you have a multimeter? If so, can you check the 3.3.v and 5v pins on the module with it plugged into your power supply? Also, what's the voltage of the supply? If you hook it back up to your computer and load the flash tool, do you see anything in the serial output window if you reset it?

thanks,
-shelby


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
JackOfManyMasterOfSome wrote:It looks to be doing something. Command line keeps printing dots. Not sure how long I should wait.

this typically indicates a problem connecting to wifi


Reply
Page 8 / 10
Share: