Pixels all dead aft...
 
Notifications
Clear all

Pixels all dead after a certain pixel

16 Posts
6 Users
0 Reactions
3,516 Views
Posts: 28
Topic starter
(@jackofmanymasterofsome)
Eminent Member
Joined: 5 years ago
[#55722]

I know that when one pixel dies, everyone after that goes out. Here's the odd thing I can't figure out. The first dead pixel isn't constant. Sometimes more or less pixels are out. And sometimes the first dead pixel flickers. I switched out the controller (esPixelStick running WLED for the esPixelStick firmware) and same thing. There are no blown fuses. The only thing I can think of that I haven't validated is maybe a power injection wire is dead? But I tested with a multimeter at the fuse and was getting about 12.4 volts of power. Does anyone know what's going on here?


15 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

My guess is V+ or V- at the flickering pixel's input has bad connection or the pixel before it has bad connection.
If it was bad data, in most cases the pixels would power up white after the bad pixel .


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I Suspect you are on the right tack with power. Checking power at the fuse is interesting but does not tell you much. You need to check voltage at the pixels that are not behaving. A pin through the wire will let you measure at the failure points.


Reply
Posts: 28
Topic starter
(@jackofmanymasterofsome)
Eminent Member
Joined: 5 years ago

One detail I forget to mention is I have 2 power injection points in 300 lights. If it was a bad v+ or v- wouldn't the power injection help recover it?


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Maybe, maybe not. It depends on whether it is V+ or V- that is broken. A broken V- will result in seemingly odd behavior. A broken V+ will result in pinking and dimmer pixels.


Reply
Page 1 / 4
Share: