Activity
 
Notifications
Clear all
11Bravo
@11bravo
Noble Member
Joined: Dec 19, 2012
Topics: 145 / Replies: 970
Reply
RE: RenardESP Information Thread

mwestling, According to this setup you don't need Mr. Porters board.

7 years ago
Forum
Reply
RE: Back to step one writting a hex file to 16f688

I'll be 73 in in February. I wished that I had got interested in this when I was lot younger. I move slow these days and deal with lower back pain a l...

8 years ago
Forum
Reply
RE: Back to step one writting a hex file to 16f688

Yes I did. I have not assembled a Renard firmware in a few years. I'm using different newer PC than I did when I got into the DIY Christmas world bac...

8 years ago
Forum
Reply
RE: Back to step one writting a hex file to 16f688

Wayne J wrote:If you dig through the program folder of MPLAB you will find one called MPASMWIN, inside it should be a exe file. send a shortcut to the...

8 years ago
Forum
Reply
RE: Back to step one writting a hex file to 16f688

So shouldn't I be opening a Renard associated.asm file to compile instead of following what the tutorial is instructing?

8 years ago
Forum
Reply
RE: Back to step one writting a hex file to 16f688

Ok got MPLABS X installed. Lost already. the screen in the tutorial is no where like what I see when I start the program. Maybe I did or did not do s...

8 years ago
Forum
Reply
RE: Back to step one writting a hex file to 16f688

I have MPLABS IDE ver 8.90 installed, I'll uninstall it and use the one in your link refers to MPLABS X

8 years ago
Forum
Reply
RE: Back to step one writting a hex file to 16f688

ok, bringing this thread back up. Now that I have time to mess with MPLABS I would like to make a HEX file from a .asm file. Here is what I have, I ...

8 years ago
Forum
Reply
RE: ESPixelstick "freeze"

I use xLights to sequence and xSchedule to run my show. When I set the ESP module to multicast in Device Setup, is it necessary to set E1.31 in xLight...

8 years ago
Reply
RE: ESPixelStick Lag

Back to the drawing board, Reducing universes didn't solve the lag issue.

8 years ago
Reply
RE: ESPixelStick Lag

jchuchla wrote:the number of ESPs has little to do with the number of universes. It also has nothing to do with the IP address of the ESPixelStick. ...

8 years ago
Reply
RE: ESPixelStick Lag

I finally got the UNSM2 setup to work in my show. I have 26 ESP-01s on 26 models running anywhere between 78 channels to 300 at the most on a model. ...

8 years ago
Reply
RE: ESPixelStick Lag

Thank you for the clarification, sorry I miss read your post. I was thinking third one down instead of third up from the bottom.

8 years ago
Reply
RE: ESPixelStick Lag

ScareCrowe wrote:Update on my issue. I switched to multicast and still had issues. Tried a different ESP and couldn't get it to work at all. Went to...

8 years ago
Reply
RE: Espixel by Bill Porter

JLStout wrote:I used Shelby's firmware and flash tool. Works good. What is the router that your are using?

8 years ago
Page 2 / 75
Share: