ESPixelStick Lag
 
Notifications
Clear all

ESPixelStick Lag

54 Posts
19 Users
0 Reactions
14.9 K Views
Posts: 1115
(@11bravo)
Noble Member
Joined: 14 years ago

Thank you for the clarification, sorry I miss read your post. I was thinking third one down instead of third up from the bottom.


Reply
sporadic
Posts: 1199
(@sporadic)
Noble Member
Joined: 14 years ago
JLStout wrote:I got it all working mostly without lag using multicast. I had 2 aps setup and they were conflicting. Took one down and all is well. I think I need to set them up as mesh, instead of both stand alone.

Don't use mesh, will cause all sorts of lag and wreak havoc. If you really need to use 2 AP's, give them different SSIDs and assign the sticks to each one manually or else they may bounce around and roam.


Reply
Posts: 360
(@jlstout)
Reputable Member
Joined: 16 years ago

Thanks Sporadic, that is good to know. I thought about doing it the way you suggested as well.


Reply
Posts: 44
(@scottn3xcc)
Trusted Member
Joined: 13 years ago

I am having similar issues. I have 13 pixel sticks deployed throughout my yard. (All within 100yds of the AP on my front porch.) The AP is a Bullet M2 High Power into a 18db gain vertical antenna. (I just swapped a regular M2HP for a Titanium version with no difference in performance.) [BTW: I have a small wireless ISP, so wireless equipment is not an issue.]

I sometimes see ping times and latency figures on the bullet of 2000ms or more. Then, for no good reason, pings come back down in the 2-100ms frame. Then, again, they go back up into the 2s area. There doesn't seem to be any "in-between" it's either "bad" or "good".

Is there a "known good" setup or set of screen shots for setting up a Ubiquity device for best performance?

I have attached a few screen shots of my config for you guys to look over and see if there are any glaring issues.
The firmware on the bullet is the latest and greatest - Firmware Version: XM.v6.1.8
The firmware on the PixelSticks is 3.1-dev dates 8/4/18

I admittedly have NOT tried any other AP, but I figure a Bullet M2HP Titanium *should* be about as good as it gets, not?

Bullet2
Bullet1
Bullet3

Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Pic 3, why MCS 3 for max Tx rate


Reply
Page 8 / 11
Share: