12mm RGB Wireframe ...
 
Notifications
Clear all

12mm RGB Wireframe question

47 Posts
10 Users
0 Reactions
23 K Views
Posts: 5
(@rainyoregonchristmas)
Active Member
Joined: 13 years ago

For pixels out, you need Pixclip 90's. When I can get them back, I don't know, hopefully soon.


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

On my wire frame stars on top of my two mega trees I used a standard wire frame clip from Christmas-LEDs.com and they work well. They may pop off when transporting or un/packing, but they stayed on fine through the season and through some pretty high winds. The big star used Boscoyo Chroma-trim strips

10363090 1737754373122926 2338332942592278131 n

WFCLPS BK AutoGenImg Medium

Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Those aren't going to work with 12mm pixels

Sent from my LG-H811 using Tapatalk


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago
MindTrik wrote:Those aren't going to work with 12mm pixels

Sent from my LG-H811 using Tapatalk

Hmmmm you should tell my 12mm pixels that. LOL Cause that's what I'm using.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

They clip on? Those look like standard 3/16" to ICAN clips....you just zip tying to them?

Sent from my LG-H811 using Tapatalk


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

They are 1/4" to incandescent, but the 12mm nodes will fit and they are pretty snug. I went the wire tie route with wire frame "Fa-La-La's" and it was a nightmare, wound up wrapping with electrical tape. Bought these clips last year and replaced the LED's on my Fa-La-La's and thought I wonder if they'll fit 12mm nodes on my stars and they did. I can send you a couple if you want to try them. IF I can find the bag of 1000. 🙂

I'll see if I can get to the stars in the shed and take a pic for you.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Is there a complete bite on the 12mm pixel?...or are you pinching the silicone jacket? Or are you clipping the wires wrapped with tape?

Sent from my LG-H811 using Tapatalk


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

I'll have to look, but I believe it fits right at the indentation or near that. I thought I took a picture last year. I just whipped them up and used ESPixelsticks to run them.


Reply
Posts: 944
(@didjareally)
Noble Member
Joined: 12 years ago
scootchu wrote:On my wire frame stars on top of my two mega trees I used a standard wire frame clip from Christmas-LEDs.com and they work well. They may pop off when transporting or un/packing, but they stayed on fine through the season and through some pretty high winds. The big star used Boscoyo Chroma-trim strips

Yup, looks just like what I printed last week, pixels snap right in and don't budge


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Pardon the rust. I whipped these up in the 11th hour.

Sent from my XT1254 using Tapatalk


Reply
Page 3 / 5
Share: