RogerH wrote:I'll give it a try tonight. I don't have anything to measure the wire thickness. But I could drop off a piece of wire in Waukesha on my lunch hour tomorrow if it's off to much.
Ok, you got my work address? I will bring the calipers with me to work tomorrow.
Kevin, I tried out the 2 clips. The second clip was very close but it looks like the diameter of the wire frame is going to be a problem. There's just not enough to grab on to. The pixel won't stay in place. With the combination of the 8 min printing time and the loose pixel wires, it makes more sense to me to just zip tie the pixels and wires to the wire frame. I appreciate the time you took to make the mod for me. On a wireframe, I don't like seeing dangling wires. There's just no faster/nicer way to add pixels to a wireframe than plain old zip ties. Thanks!
No problem
Sent from my SGH-M919 using Tapatalk
Pixclips would work. The paracord feature fits a 0.114 minus gage pin just fine. The clips are in production now, I have an ETA on completion, but not a definite date of when I can ship them. Hopefully by months end. The attached photo shows a 12mm pixel, a pixclip and a 0.114 gage pin. Also the wires can tuck into the 0.500×0.250" slot for rectangular bar stock to keep things neat and trim.
Yeah...a little mod and widening of the clip I sent you and it would work
Sent from my SGH-M919 using Tapatalk
@MindTrik, is that your pixel clip on Thingiverse? If so, thank you. I just printed one out of clear eSun PETG and it works perfectly for my wireframe deer. I'm not sure how well the PETG will hold up to UV but I plan on misting the pixels and clips with 303 Aerospace protectant ( https://www.amazon.com/303-30306-Protectant-Trigger-Sprayer/dp/B000XBCURW ).



