12mm RGB Wireframe ...
 
Notifications
Clear all

12mm RGB Wireframe question

47 Posts
10 Users
0 Reactions
23 K Views
Posts: 255
(@rogerh)
Reputable Member
Joined: 12 years ago

I need some clips like that. I need them to clip onto 9 ga wire. I will need to print up a couple hundred for the ghost frames I'm going to build this week.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Try this Roger...might need adjustments...let me know http://www.thingiverse.com/thing:1760065


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

Bad link Kevin.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Try now


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago
RogerH wrote:I need some clips like that. I need them to clip onto 9 ga wire. I will need to print up a couple hundred for the ghost frames I'm going to build this week.

If you can put a set of calipers on your wire (or drop a inch or so of it off at the house one day), I can get you something to print I am sure.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

If it follows standards...the diameter is .11440"

Sent from my SGH-M919 using Tapatalk


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

Heh. kevin got a design up.

I was thinking of one similar but I was going to put a wire channel under the clip so the wires are held in place too. but that one works.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Adding one with a wire channel, GOOD IDEA! Use same link as above.


Reply
Wolfie
Posts: 2225
(@wolfie)
Noble Member
Joined: 11 years ago

https://www.tedpella.com/company_html/wire_gauge.htm
http://www.louispage.com/blog/bid/7075/Understanding-Wire-Gauges-Used-In-Welded-Woven-Wire-Mesh-Fence

Those seem to indicate 0.1483".

Electrical wire gauge is different than steel wire gauge. Electrical is 0.1144 for 9ga. Fabrication wire is 0.1483 so if you made your clip for 9ga electrical (0.1144) it might be too tight for 9ga construction/fabrication (0.1483).

So it depends on whether his "9ga" wire size is using AWG or fabrication gauge size ratings. Thats why I asked if he could throw a calipers on it to know for sure which one.


Reply
Posts: 255
(@rogerh)
Reputable Member
Joined: 12 years ago

I'll give it a try tonight. I don't have anything to measure the wire thickness. But I could drop off a piece of wire in Waukesha on my lunch hour tomorrow if it's off to much.


Reply
Page 4 / 5
Share: