12mm RGB Wireframe ...
 
Notifications
Clear all

12mm RGB Wireframe question

47 Posts
10 Users
0 Reactions
23 K Views
Posts: 255
(@rogerh)
Reputable Member
Joined: 12 years ago

I've only made one wire frame candle so far an zip tied the pixels flat. I liked the way each pixel illuminated the adjacent pixel. I also use plastic fencing from HD. The spacing is 1/2" x 3/4" which is perfect for pixels. I've made two 3' x 5' props with the fencing. I'm using 100 pixels on the first and 200 on the other. Both look nice. I guess it depends how much detail you need in your prop. Laying the pixels down looks good but limits the detail you can create.


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

Something like this.... Basically just clamps the 12mm pixel. It prints without having to use any bridging, etc. I also did one of the clip system that Wolfie and I are working on.

Clip

Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

I don't have a drawing program here (or anywhere for that matter)so I can't put together my idea, but could you do a 90 degree on the grip part (on the rod)?
I'm afraid that the pixel would be sticking out too far if directly from the prop. (Perhaps not, but...)


Reply
MindTrik
Posts: 1542
Topic starter
(@mindtrik)
Noble Member
Joined: 16 years ago

I see what you're saying, absolutely. In a situation like this, trying to get the pixels to point straight out...flat bar is going to be a better solution just because no matter how tight that clip is...it's going to want to roll. I will do one with a flat bar attachment point too.


Reply
jnealand
Posts: 956
(@jnealand)
Prominent Member
Joined: 19 years ago

I have found that viewing nodes from the side is just fine. I have had 12mm nodes hanging from my eves and pointing to the ground for 4 years. They are plenty bright and the effort to make them point to the road would be a lot of effort for little gain in my opinion. In fact looking a videos and pictures of the front of my house where I do have nodes pointing toward the street on my porch columns shows very little difference in brightness at least to my eye.


Reply
Page 2 / 10
Share: