Waterproofing Pixel...
 
Notifications
Clear all

Waterproofing Pixels

34 Posts
13 Users
0 Reactions
7,133 Views
Posts: 255
Topic starter
(@townshend-lights)
Reputable Member
Joined: 11 years ago
deonb wrote:Oh man - you're in for a hard time. I remember running through my pixels every night and spraying them - and that's after I plasti-dipped the whole bunch.

Next time you buy bullets from an unknown supplier, don't just ask for waterproof, or "IP68" or whatever. Ask specifically if they're Epoxy-resin injected. That's really the only thing that works.

They are, but I've noticed on some of the ones I've replaced they are not always sealed fully as water has dripped out of one or two. Strangely these ones were out last season (also with rain) and none of them did this.

So perhaps the resin shrinks over time? We also get very hot here 38+ deg Celsius as I'm in Southern Hemisphere.

Anyway the season is almost over. I think I'll go projection mapping next year instead. :spox:


Reply
Posts: 909
(@kenoman742)
Prominent Member
Joined: 14 years ago

Well, it ended up worse this time. I went out today and tried to identify and dry questionable pixels on the tree. I ended up replacing one. Tonight the lights are running and I see 3 or 4 dead lights and several of the last strings on the tree are flashing very noticeably. Oh well, at least I know where I'll be spending my time tomorrow. Anyway, if we didn't have these issues to deal with we'd just be bored with it all. Good luck everyone.

Ken


Reply
joeytx
Posts: 249
(@joeytx)
Reputable Member
Joined: 19 years ago

My 12mm square nodes are two years old also and the Epoxy resin that seals the back of the silicone shell is cracking. Not much the supplier is going to do. So I found that the Gorilla Waterproof Patch & Seal Spray, Clear, sprayed onto the backs is solving the problem for this year. My pixels are mounted in Boscoyo Mounting Strips and attached to my Ferris wheel, so they were relatively easy to spray. Not something I want to do every year.

Joey


Reply
Posts: 1763
(@santacarl)
Noble Member
Joined: 19 years ago
joeytx wrote:My 12mm square nodes are two years old also and the Epoxy resin that seals the back of the silicone shell is cracking. Not much the supplier is going to do. So I found that the Gorilla Waterproof Patch & Seal Spray, Clear, sprayed onto the backs is solving the problem for this year. My pixels are mounted in Boscoyo Mounting Strips and attached to my Ferris wheel, so they were relatively easy to spray. Not something I want to do every year.

Joey

My first big batch of pixels were the square ones but I had the same issue you described....water would leak into the pixel from the back side around the edges....I was replacing dozens of them every time it rained so I tossed ALL of them and went with bullet pixels....that solved my problem until the past couple of years....now the bullets are leaky but still not as bad as the square ones.... I tried to reach out to the supplier (domestic) of those square ones and ask for a solution or at least tell them they have a problem but all I heard back was crickets.... I've been going direct to China since but the recent spate of leakers has me rethinking my source...


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

I just got a monsoon the night before and my [round] pixels were the most reliable part of my display. My lovely night consisted of debugging ground faults in the AC in the mud. Lots of drive-by's, and all they got to see was the pixel portion. I should try some of this same epoxy, resin stuff you all are recommending on my AC's.


Reply
Page 5 / 7
Share: