Waterproofing Pixel...
 
Notifications
Clear all

Waterproofing Pixels

34 Posts
13 Users
0 Reactions
7,132 Views
Posts: 106
(@puppycrack)
Estimable Member
Joined: 6 years ago

As a first timer with 6000 pixels, both bullet and square, some 30' off the ground (roofline), living in Upstate NY with snowy/rainy/cold Christmas, this thread terrifies me.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
puppycrack wrote:As a first timer with 6000 pixels, both bullet and square, some 30' off the ground (roofline), living in Upstate NY with snowy/rainy/cold Christmas, this thread terrifies me.

It should and it should not. You need to accept that wide temp fluctuations plus moisture are not your friend and you must plan for the negative impact. You must make sure your pixels are accessible for maintenance / replacement when (not if) the pixels go bad. I have my roofline pixels on pvc pipes attached to pullies and nylon lines. They can be lowered to the ground for maintenance, making it safer to fix issues (note I did not say simpler or easier) in unpleasant conditions.


Reply
Posts: 106
(@puppycrack)
Estimable Member
Joined: 6 years ago

Thanks Martin. While I realize failure is inevitable, I had been under the impression that I might be replacing a few pixels here and there in the off season, not every time it rained. I mean, isn't that what the epoxy is for? Based on this thread, at least anecdotally, it seems to be getting worse year by year, probably by cutting corners to save a few cents in manufacturing. If that's the case, I think it will drive lots of folks away from the hobby, reducing demand for pixels, which will probably cause manufacturers to cut even more corners to remain profitable. If it so happens that I have pixels going out with every rain, well, you might be seeing a lot of my pixels and controllers for sale here in 2023.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

not so much with every rain. I have a 1600 pixel mega tree that ALWAYS has a pixel die two or three days before Christmas. My 2000 pixel matric has a bad pixel every few days. my 2000 pixels on the eves have 2-3 bad pixels a season. They were all purchased at different years with the matrix being the newest and to me, the lowest quality. My arches and candy canes (3000 pixels) are my oldest and most reliable pixels with zero failures the past four years.


Reply
Page 7 / 7
Share: