Sandevice E682 Powe...
 
Notifications
Clear all

Sandevice E682 Power Problem

70 Posts
8 Users
0 Reactions
13.2 K Views
Aurbo99
Posts: 2804
(@aurbo99)
Famed Member
Joined: 19 years ago


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

i fixed the soldering points

When I finished soldering it and I tested it all worked for about 10 mins then it started blowing fuses and I cant get it resolved


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

the 2A fuse (lower right) If this fuse blows repeatedly, and the power jumpers are correct, the most likely cause is a shorted diode,
D1. D1 is a black part with a silver band and is located beneath the 3.3v regulator. An ohmmeter can be used to test D1
for a short. With power off, meter on ohms scale, check resistance across D1, then reverse the meter leads and check
resistance again. A shorted diode will show near 0 resistance on both tests. A good diode will show a higher resistance
on one test and a lower resistance when meter leads are swapped. If D1 is suspected to be shorted, remove it from the
circuit by de-soldering or cutting one lead


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago
TazChaLet wrote:the 2A fuse (lower right) If this fuse blows repeatedly, and the power jumpers are correct, the most likely cause is a shorted diode,
D1. D1 is a black part with a silver band and is located beneath the 3.3v regulator. An ohmmeter can be used to test D1
for a short. With power off, meter on ohms scale, check resistance across D1, then reverse the meter leads and check
resistance again. A shorted diode will show near 0 resistance on both tests. A good diode will show a higher resistance
on one test and a lower resistance when meter leads are swapped. If D1 is suspected to be shorted, remove it from the
circuit by de-soldering or cutting one lead

I was thinking the same , definitely a short somewhere .
The unsoldered gnd of the regulator shouldn't of had an effect on the 2a fuse


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago

Edited: I had posted an incorrect response


Reply
Page 5 / 14
Share: