Sandevice E682 Powe...
 
Notifications
Clear all

Sandevice E682 Power Problem

70 Posts
8 Users
0 Reactions
13.2 K Views
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

Can I remove that diode and test to see if that is what causing the problem or do I need to replace it in order to test


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

The controller will operate fine without D1 BUT YOU WILL NOT HAVE PROTECTION AGAINST OVER-VOLTAGE AT
THE PIXEL POWER INPUT J19. For example, if you have the board jumped for 5V pixel power, and you accidentally
connect 12V power instead, D1 will protect the controller electronics from damage by blowing the 2A fuse. If D1 is not
present and you connect +12V power to a board jumped for 5V, it will likely damage the controller. So, if you
operate without D1 present, use caution


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

test the diode with your ohm meter it will let you know if it is bad then you can remove and replace and test and see if things work all this info was found on the sandevice pages


Reply
Posts: 64
Topic starter
(@techs21)
Trusted Member
Joined: 16 years ago

Ok it was the D1 diode that did it, so now I can get it to power up but the red and green LED flash 19 times and stop and then flash 19 times again and just continues in that loop anyone know why this would be happening

and thanks for all the help for the first problem


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

do you have the ethernet cable connected to the controller


Reply
Page 6 / 14
Share: