problem with 682
 
Notifications
Clear all

problem with 682

24 Posts
7 Users
0 Reactions
6,969 Views
Posts: 2171
(@mschell)
Noble Member
Joined: 18 years ago

When you issue a TEST 1 command, it will set ALL the defined lights on all clusters to Red.

Now, if you have different TYPES of pixels defined on cluster 2, then when you plug them in, you may get different results, since the pixel TYPES aren't compatible.

Based on your original posting of E682 setup, you have WS2801 type of pixels on cluster 1 and 2, and other types on clusters 3 and 4.

Henri,
You need to configure each cluster in the way you attach the pixels. So if you have 4 strings of 50 WS2801 pixels, you need to tell the E682 that you have:

a. pixels per string -> 50
b. type of pixel -> WS2801
c. how many of the outputs you are using -> 4
d. DMX universe for cluster

All these are different commands and have to be done for each output cluster.

If you don't tell the E682 these things, it's going to take the default or whatever had been set before, and you should NOT expect to be able to connect any string to any output and have it work correctly.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

The config page Henri posted is the default page that the e682 is shipped with .

I would suggest a good read of the opmanual and a even greater play with the commands to get familiar with what they do .

this should be done without attaching any lights.

don't forget the command : Save 0 after making a change . also Boot 999 is required after changing certain attributes .

cheers


Reply
Posts: 1792
Topic starter
(@barbotte)
Noble Member
Joined: 17 years ago

k thanks to all for your input ... i understand that it is a new ball game for me so all i wanted to do is make sure i was in the righ direction and that my controler were build propely as i need to buil 2 more lol ... more to fallow later thanks again
cheer


Reply
Posts: 109
(@max-paul)
Estimable Member
Joined: 14 years ago

Ok, to answer your question. The 4 jumpers on the left side are to remain off, unless you are using DMX devices that require a BALANCED signal. I dont know for sure, but suspect that all of the pixel devices we are working with will not require a balanced signal.
But I agree, your going to need to learn how to set-up each cluster (4 groups of 4 connectors) to work with the strips or pixels. This could very well be the problem your having. I was not able to under stand this "81" and "82". And you need to keep it straight as to what board your working with. 681 and 682 is not interchangeable, its either one or the other.


Reply
Page 3 / 3
Share: