One thing to always remember with this DIY and electronics. NEVER ASSUME.
Ditto, thanks for the update Jim. Hey we all need some down time. Hope your enjoying yours.
I think I say this for everyone. Aaaaahhhhhhhh!!!!!! This is the next best thing to sliced bread and butter when it comes to pixel controllers. Talkin...
Or is that a voltage dropping resistor I am seeing below the LED? Seen the Chinese select the wrong size (resistance and or wattage) and have the resi...
Moondew, was there any rain or moisture in the past few days that might have caused this?
Skunberg wrote:If you're in any kind of a hurry don't wait for the little one. It will be a couple of months, maybe this fall before it's available. A...
Thank you MrSmoofy. I thought I would never find old R2D2 and CP3O again.
Not using a calculator just running the numbers fast in my head. A 350W 24V power supply would provide about 17 amps output. We use 12ga wire with 25 ...
Lowepg, I think I am going to swap out that "oy" with OUCH! 😆
neilric99 wrote:Ray showed me the photo's of the moulding for the new new technicolor pixels which he says will definitely be IP68 last week. So he is...
pixelpuppy wrote:I disagree. Running with "all on" will draw the most current and generate the most heat. This is what you want when the objective i...
Well on reason not to use a socket is cause it inserts another failure point. If you do decide to put in socket. Dont go cheap, get a good socket that...
Thanks Jeff, fas an electrician I have always had to go back to the books/charts to figure out the right size of wire. I have had the mindset that 14g...
Agree with budude. Throw the string or strip in the freezer over night. Then take out and quickly attach to the controller and cycle through the color...
