Hoping to get some opinions on some pixel strip. I am comparing the 30LED-30IC per meter vs the 60LED-60IC per meter strip. I am looking to make some candy cane poles, most likely 3 inch pvc 36 inch tall wrapped in the pixel strip. trying to decide if the 60/60 is overkill or if the 30/30 will be suitable for this project.
Many opinions. I for one would say DO NOT DO IT. I have removed all of those 1:1 strips from my show due to reliability issues. Use 3:1 strips.
I have 30/30 strips inside my arch tubes and they have held up well (no lost pixels to date). I would not use them unless very well protected.
What’s your viewing distance? 60/60 is close to one pixel every half inch and won’t provide a great benefit for most applications. The most I use is 30/30. If using strips, I’d just run the strips vertically with the pixels aligned rather than wrapping the strips around the poles. Use software to make the striped pattern.
Alternatively, you could look at the “pixel pole” system Boscoyo makes. That would allow you to use flat or bullet nodes (which are much easier to replace if one goes bad).
ezellner wrote:I have 30/30 strips inside my arch tubes and they have held up well (no lost pixels to date). I would not use them unless very well protected.
I agree, I use 60/20 inside my arch tubes and they have held up well. I would not use them attached outside of anything directly in the elements (my 2). You can almost do with nodes what you can do with strips given the flexibility of items you can attach to nowadays (pvc,Boscoyo strips, etc). If you could drill 12mm (1/2") holes in the 3" PVC and insert some bullet nodes from inside the PVC so they were sticking out, that might provide you with an interesting look.
