Notifications
Clear all

dumb rgb stips

14 Posts
10 Users
0 Reactions
8,139 Views
Posts: 145
Topic starter
(@perfection322008)
Estimable Member
Joined: 10 years ago
[#50475]

I have always been told the only dumb question is the one that's not asked...... Looking at buying some dumb RGB strips can they be cut and still work properly ?


13 Replies
DrNeutron
Posts: 2016
(@drneutron)
Noble Member
Joined: 14 years ago

Yep, I used the standard 5050 RGB 12V strip and they were cuttable every 3 inches or so.
The strips you are looking at getting, are they in silicon sleeve or epoxy coated?


Reply
Posts: 145
Topic starter
(@perfection322008)
Estimable Member
Joined: 10 years ago

Haven't thought that far ahead yet. But what would you suggest

Sent from my SM-G950U using Tapatalk


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

When you look at the strips every few inches there will be solder pads, you can cut them across the solder pads.

Kinda depends on your planed use for them, if they are going to be protected then the coated are fine (IP65). If they are going exposed then the Sleeved ones are what you want. jsut make sure to seal the ends good.


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

In my experience, the epoxy-embedded are a pain to cut and re-solder. I used them years ago on a project and even when using connectors specifically designed to make connecting cut sections easier, it was still difficult. I’d probably go for sleeved.


Reply
Page 1 / 3
Share: