Great information o...
 
Notifications
Clear all

Great information on Pixels and Pixel Controllers

3 Posts
2 Users
0 Reactions
2,017 Views
rayhjr
Posts: 972
Topic starter
(@rayhjr)
Noble Member
Joined: 12 years ago
[#53104]

https://youtu.be/9ttEAyiyTAI
This is a very in depth analysis on pixels (5volt, 12 volt, regulated vs resistor) and pixel controllers. You name it Keith tested it (most common anyway). It should be a must see, especially anyone new to pixels, imho. Enjoy!

Sent from my SM-A505U using Tapatalk


2 Replies
TomsLEDs
Posts: 443
(@tomsleds)
Honorable Member
Joined: 7 years ago

Learned 1 thing from the video already, alarm wire is only 26 awg. Don't think I will ever be using it for anything.


Reply
rayhjr
Posts: 972
Topic starter
(@rayhjr)
Noble Member
Joined: 12 years ago
TomsLEDs wrote:Learned 1 thing from the video already, alarm wire is only 26 awg. Don't think I will ever be using it for anything.

Not only that but some Pixels have 20 to 24awg in there construction. Which to a degree is ok but you might not want to use them in Long Runs where they may overheat and cause a problem.
I just purchased a lot of 500 and were advertised as 18awg. Welllllllll........ 18 is being generous at best, and when I cut the connector off to install My connector and stripped the wire insulation off........... Copper Clad. That reduces it again by a awg size. So now my 18awg Pixels are in the neighborhood of 22awg for all practical purposes. Not complaining. I'll still use them, I just have to know that they are NOT 18awg.
Another thing I found interesting was the advantages of the 33ohm resistor on the Pixel output of the controller.
I have watched the video many times and will watch it many more I'm sure. Find something new every time.


Reply
Share: