ESPixelStick Observ...
 
Notifications
Clear all

ESPixelStick Observations

21 Posts
9 Users
0 Reactions
5,156 Views
Posts: 226
(@thomasled)
Estimable Member
Joined: 5 years ago
Instead look at this one ( https://www.amazon.com/gp/product/B0...?ie=UTF8&psc=1 ). It comes in 3 and 4 wire, pure copper, and 18 awg.

FWIW, if you measure the copper you will find that it's actually 20AWG copper instead of the advertised 18AWG.

Wire gauge exaggerations are a common theme with Chinese made LED wire, especially the ribbon type. I have yet to buy a roll of "imported" LED ribbon wire that had an accurate American gauge spec.

- Thomas


Reply
Mat-Moo
Posts: 39
(@mat-moo)
Trusted Member
Joined: 11 years ago
ThomasLED wrote:Converting to an external antenna requires a ESP8266/ESP32 board that has the optional IPEX / U.FL connector feature. My DiY ESPixelSticks are based on the ESP32 TTGO T8 board, which has it. Other ESP boards offer it as well, but it's not a common feature.

To use the external antenna a jumper (0 ohm SMD resistor near the internal antenna) is relocated and a IPEX / U.FL to SMA coax cable is installed. A common rubber ducky dipole stick is then screwed onto the SMA connector. Not too difficult but the soldering requires some experience with reworking SMD components.

Sorry, but I don't have photos or my board. But the ESP32-CAM board has this feature and I found an online resource that explains the rework:
https://randomnerdtutorials.com/esp32-cam-connect-external-antenna/

- Thomas

Do you know what gain your external Antenna is? I’ve seen 3db and 6db ones, onboard is 2db so 3db is a 50% boost but doesn’t seem the effor over 6?


Reply
Posts: 226
(@thomasled)
Estimable Member
Joined: 5 years ago

The onboard antenna may have the same gain specification, but in practice they don't provide the same performance. My comparisons with external dipoles have shown at least 2X longer range vs. the internal PCB microstrip (or ceramic) antennas. Signal fading and dropouts are significantly reduced too. So I'd say the external antenna has the equiv of at least +6dB better performance than the internal antenna.

I use the ESP8266/ESP32 internal antennas on my home automation devices that are near a router. But for things installed outdoors, or those that need a very reliable connection, the external antenna is my go-to solution.

BTW, I use standard 2-3dBi gain 2.4GHz dipoles (common rubber ducky stick). My HP Network Analyzer has shown the higher gain ducky antennas tend to be poor implementations that often reduce RF performance.

- Thomas


Reply
Mat-Moo
Posts: 39
Posts: 226
(@thomasled)
Estimable Member
Joined: 5 years ago

For the reason I mentioned earlier, I suggest skipping the +6dBi. The +3dBi choices tend to be less risky.

A good source for free antennas are from retired 2.4GHz routers stashed in the closet / junk box. Especially from respected name-brand routers. BTW, they will typically have RP-SMA connectors rather than standard SMA. So for these freebies you will probably need to choose a U.FL/IPX cable that has a RP-SMA connector.

- Thomas


Reply
Page 3 / 5
Share: