ESPixelStick Observ...
 
Notifications
Clear all

ESPixelStick Observations

21 Posts
9 Users
0 Reactions
5,155 Views
Mat-Moo
Posts: 39
(@mat-moo)
Trusted Member
Joined: 11 years ago

Yep, it's the connector part I am unsure about


Reply
Posts: 226
(@thomasled)
Estimable Member
Joined: 5 years ago
Yep, it's the connector part I am unsure about

If the ESP board supports an external antenna then it will have a U.FL connector on it (or a place to solder one). U.FL is also known as IPEX (different brands, same layout). So your antenna cable will need to have a U.FL/IPEX connector on it.

2.4GHz dipole antennas are produced with two different types of SMA connector, standard SMA and RP-SMA. The difference between them is the location of the center conductor's mating pin & socket. When I get to choose I prefer SMA since my RF equipment is setup for that connector. But if the selected antenna was equipped with RP-SMA then I'd use a U.FL connector with RP-SMA. I have a lot of standard SMA equipped WiFi antennas on hand so that's what I use.

Basically, YOU get to pick RP-SMA or SMA. Then ensure both the WiFi antenna and RF adapter cable have the same type on them. TLDR; Don't mix RP-SMA and SMA, they won't fit together.

- Thomas


Reply
Mat-Moo
Posts: 39
(@mat-moo)
Trusted Member
Joined: 11 years ago

So the link I posted tith cables and antenna can’t really go wrong 🙂


Reply
Posts: 255
(@townshend-lights)
Reputable Member
Joined: 11 years ago

I have had issues trying to get the SD card working on a ESP32, So I tried on a D1 Mini and it works a treat. Here's a short video of it running 1188 pixels (this is the max pixels the D1 mini will let you run. My matrix actually has 1244 pixels) from one pin and the sequences on the SD card. I'll upgrade to the ESP32 when it's more stable.
https://www.youtube.com/watch?v=_y9OYz6aCYg


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
townshend lights wrote:I have had issues trying to get the SD card working on a ESP32, So I tried on a D1 Mini and it works a treat. Here's a short video of it running 1188 pixels (this is the max pixels the D1 mini will let you run. My matrix actually has 1244 pixels) from one pin and the sequences on the SD card. I'll upgrade to the ESP32 when it's more stable.

What version of the ESP code were you running? What Hardware where you using? What were the issues? Hard to fix anything from a description like this.


Reply
Page 4 / 5
Share: