So the link I posted tith cables and antenna can’t really go wrong 🙂
Yep, it's the connector part I am unsure about
Was looking at - only 3dbi though vs 6dbi - thoughts welcome
ThomasLED wrote:Converting to an external antenna requires a ESP8266/ESP32 board that has the optional IPEX / U.FL connector feature. My DiY ESPixelSt...
MartinMueller2003 wrote:use V4 and use hardware that has an SD card. Then use an FPP as master. Total WiFi load drops to almost nothing and the number...
Any other options I should be looking at? I'll watch/record one tonight (All my shows are done in Vixen3 BTW), and have always exported at 20fps, alwa...
Thanks - been through that article, it's what's led be to buy the Nano station - AS you can see, I've repositioned and now have pretty good signal (I ...
11 esp's and the only one that is showing any Packet errors is the ESP32 - everything else shows 0 packet errors, but some out of sequence (doesn't bo...
So after all sorts of issues, and being behind schedule I know have a running show. But my grid feels like it’s badly lagging… so what can I do to imp...
Also you may need elevated permissions?
Are the universes being used anywhere else? Why are you using 3 channels, you cold just use one.but looking at that seems ok
I had similar funnies, seems to be quite finickity when comes to programming. If you use a serial monitor you can press boot and see the output, then ...
Stupidly I hadn't put the right details in to connect to wifi - doh, too late now maybe tomorrow, but gotta start getting something up now!
Must be cached, if I run from command line, it works! "c:\Temp\EspixelStick 4\bin\win32\python3\python.exe" .\bin\upload.py --chip esp32 --baud 46080...
