And pardon my use of "pixels." Bad habit, I call any light that is controlled in a light show a "pixel", even dumb incandescent lights. I've been yell...
PulseMesh is tied to a show controller technology, not a lighting technology. It currently supports FPP and LOR (and possibly the xLights show control...
BTW, the fortune telling witch video is a rear projection from a short throw projector. The screen is a fine mesh nylon cloth that is semi-transparent...
I thought I would share my story and the solution I ran with at my Halloween Haunted House event. Brief History: In the past my holiday events used l...
50 vs. 75: Either will work. But low loss RG6 (75 ohm) is easily obtained from the local big box store. Keep in mind that the build uses F-connectors ...
Understood. Have a great Christmas!
Sorry, did not see this until today. Keep in mind that the default AP password can be overridden by your user settings. There's some possible soluti...
As mentioned, only 2.4GHz in supported. If your WiFi credentials have changed, or the router's DHCP has taken the IP address you reserved in the Pixe...
Regarding co-existance, I found numerous posts saying that VS-Code can safely co-exist with Visual Studio. I overlooked the comment where you were c...
Shouldn't C8 and C9 (the audio coupling capacitors) be non-polar? Feel free to use non-polar at C8 and C9. But the recommended electrolytics are fin...
Nice work. Cool project. - Thomas
Port usage is as follows: Web Server: 80 HTTP Controller: 8080 MQTT Controller: 1883 Values are declared in PixelRadio.h file. - Thomas
If I just mount the PCB board in a case say along with a BBB16 controller would everything be OK PixelRadio's RF power is low, so should play nice ...
I then put the ESP32 on the PCB and gave it 12V (outer contact being ground/negative and inner contact being 12V). However, the ESP32 doesn't come on,...
I agree, the brower's failure to access PixelRadio could have something to do with the guest WiFi. As suggested by Mike, connect it to your other WiFi...
