sporadic wrote:I haven't looked at the protocol yet, but I'll put it on my todo list.
Make that two for wanting to use it with the TLS 3001 pixels.
Kev7274 wrote:I'll be looking out for the Beta tester info.
Count me in too.
I would be looking for at least 3 to drive WS2812's
Could these be configured to talk directly to a Pi or BBB that had an EDIMAX that was only 2 feet away
Or do they have to talk to a router 200 feet away first, then come all the way back.
The BBB will have its hands full running 8 p6 panels on my back so direct drive is not an option.
These look a lot smaller and cheaper than an E680 to fill in some pixels on my arms and hat.
Bonus, no need to hook up communication wires. Only battery power.
Looks like the candy man jacket is getting an upgrade.
joel
jrock64 wrote:I would be looking for at least 3 to drive WS2812'sCould these be configured to talk directly to a Pi or BBB that had an EDIMAX that was only 2 feet away
Or do they have to talk to a router 200 feet away first, then come all the way back.The BBB will have its hands full running 8 p6 panels on my back so direct drive is not an option.
These look a lot smaller and cheaper than an E680 to fill in some pixels on my arms and hat.
Bonus, no need to hook up communication wires. Only battery power.Looks like the candy man jacket is getting an upgrade.
joel
They can connect to anything that can be setup as an Access Point.
madsci1016 wrote:They can connect to anything that can be setup as an Access Point.
Currently FPP doesn't support this, but we have it on our TODO list.
CaptainMurdoch wrote:Currently FPP doesn't support this, but we have it on our TODO list.
Good to know.
Back to plan B
Joel
Wait...the ESP has its own IP in unicast mode. You're only adding it in FPP as a unicast device...
Sent from my LG-H811 using Tapatalk
hey evereyone! first of all thanx mr fork in eye for the code! i just build myself an espixel just tested it and it works very well 🙂 BUT, there is alwayes a but.. 😉 if i send data from luminair it works, if i send data from vixen it works but i want to drive my pixels with JINX software, but i get a black pixels when i start the output in jinx.. i tryed it in multicast and on its ip mode and it does put out some kind of signal (looks like it sends out 0 to al channels, because when i put al channels high in luminair, close luminair the pixxels will stay high, but when i start the jinx output all lights go out.) if i send luminair data from my tablet the ights are on and when i start the JINX at the same time the output the lights start flickering like they get two inputs (i know this flickering from driving two artnet signals to one artnet to dmx node).but if i play something in jinx the pixxels stay off 🙁 maybe my settings? did someone tryed using jinx with the espixel ? it should work with jinx i think.. thanx in advance Daan
Yes, I use ESPixel stick firmware with Jinx! software. I do not use DHCP - only static IP.
Here is my Jinx! settings tested with with this firmware
http://www.seasidecustoms.com/plili/jinx_wifi pixel-RBG.rar
Any update on when these may be available again???
