Notifications
Clear all

E682 issues

33 Posts
9 Users
0 Reactions
10.7 K Views
Posts: 313
(@ee351)
Reputable Member
Joined: 13 years ago
ebrady wrote:When you switched the pixels on did any of them randomly light and then go off when your controller came online?

Sometimes pixels would randomly light before power was applied to the controller. Other times they would be stuck on white. When stuck on white the data would still be passed to the next pixel. This problem only affected the first or second pixel in a string. My cable length was about 7' from the PS to the first pixel.


Reply
ebrady
Posts: 670
Topic starter
(@ebrady)
Prominent Member
Joined: 17 years ago
EE351 wrote:Sometimes pixels would randomly light before power was applied to the controller. Other times they would be stuck on white. When stuck on white the data would still be passed to the next pixel. This problem only affected the first or second pixel in a string. My cable length was about 7' from the PS to the first pixel.

That sounds like the behavior I have. When you set up this year, try the following power on sequence in this order (if possible).

1. Switch on power supply wait 1 to 2 seconds.
2. Connect 5v to pixels
3. Connect 5v to controller

I would be interested in knowing if this works for you. Thanks!

Ed


Reply
Posts: 313
(@ee351)
Reputable Member
Joined: 13 years ago

I'm designing a new controller for this year's display, so I'll definitely add a switch to the 5 volt side of the power supply feeding the pixels. One thing I didn't mention was that the atx power supply took about 3 seconds to reach 5 volts when it was outside (about 40-50F). I never experienced any problems when the pixels were in my garage for testing (where the power supply was presumably warmer).

I'll also be adding one of these to my enclosure to monitor the voltage:
http://www.ebay.com/itm/DC-2-5-32V-LED-Panel-Voltage-Meter-3-Digital-Display-Voltmeter-Motor-Motorcycle-/400546537521?pt=LH_DefaultDomain_0&hash=item5d426f2031


Reply
Page 7 / 7
Share: