Notifications
Clear all

E682 issues

33 Posts
9 Users
0 Reactions
10.7 K Views
ebrady
Posts: 670
Topic starter
(@ebrady)
Prominent Member
Joined: 17 years ago
jchuchla wrote:Well it looks like you're getting a pretty thorough look into this. I'm surprised I haven't seen similar threads in the past. There's many GECE trees out there. I'm surprised someone else hasnt come up with problems like this.
Does your ps have a voltage adjust pot? Can you try trimming it up a bit to see if that helps?

--Jon Chuchla--

Sent from my iPhone using Tapatalk

I agree, I would think this should have come up before now, but if it is specific to the 2012/2013 version of the lights, maybe not as most everyone here likely bought them on clearance last January. :).

It could be that I just have a crappy power supply and the bulbs are fine.

Thanks for all your input on this....

Ed


Reply
Posts: 313
(@ee351)
Reputable Member
Joined: 13 years ago

I experienced similar issues with my gece pixels. I used an atx power supply and 16\3 extension cord cable also. Often times I would have to power cycle 20+ times to get all the pixels to enumerate correctly.


Reply
ebrady
Posts: 670
Topic starter
(@ebrady)
Prominent Member
Joined: 17 years ago
EE351 wrote:I experienced similar issues with my gece pixels. I used an atx power supply and 16\3 extension cord cable also. Often times I would have to power cycle 20+ times to get all the pixels to enumerate correctly.

I would be interested in understanding your setup.

Specifically,

Are your pixels new? (i.e Newer version with push button controller, no remote and 6 volt supply?)

Are you powering pixels through the E682?

How many stings and pixels per string?

How are you powering up the power supply? Switch, plugging it in? Other?

Thanks!
Ed


Reply
Posts: 313
(@ee351)
Reputable Member
Joined: 13 years ago

1. My pixels were the wireless remote type with the 5.6v power supply
2. I was using a self made controller (pic micro and rn-xv wifi) controller was powered separately from the pixels.
3.12 strings of 36 pixels.
4. I would apply power to the pixels first and then power on the controller. I was using those cheap wireless outlets to switch the pixel power supply on first and then the controller ps.


Reply
ebrady
Posts: 670
Topic starter
(@ebrady)
Prominent Member
Joined: 17 years ago

When you switched the pixels on did any of them randomly light and then go off when your controller came online?


Reply
Page 6 / 7
Share: