What protocol do th...
 
Notifications
Clear all

What protocol do these lights use?

8 Posts
5 Users
0 Reactions
2,367 Views
Posts: 4
 Ibid
Topic starter
(@ibid)
Active Member
Joined: 12 years ago
[#33494]

I'm slowly working out how to make my system work. I have 9 strings of lights 50 LEDs long. 4 strings of one type and 5 of another. None of which came with any documentation. The four strings I've got worked out and working properly. I'm hoping you fine people can help me with the other 5. I can't figure out what communication protocol they use. I've gone through LPD6803, WS2801, GE ClrEff, 1804/2811, 16716, LP880x, 981x, TLS3001, DMX, and RENARD57k and each time the lights respond "Hodor." They light up, sure, but don't respond to data.

They're a 3 wire system with red, green, and white wires (+/data/- respectively). The chips running each light are labeled LX1003. Upon delivery, the green and white wires have black clips on them while the red wires are loose. And that's all I know. Can you tell what I have and/or what protocol to use? Or is there a way to add additional protocols to an E682 controller?

My setup - Vixen 3 running a Pixel System 1 (using a SanDevices E682 controller)


7 Replies
Posts: 484
(@boof63)
Honorable Member
Joined: 15 years ago

Not sure , but sounds like INK1003 at a guess by the chip label.
If that's the case then 2811 protocol should work,
( have ink1003 running as 2811) baud rate is 2400 tho, not flat out.
Hope this provides some help. Hopefully someone with more info will step up.
cheers and good luck
Boof63


Reply
Posts: 91
(@rednelb)
Estimable Member
Joined: 13 years ago

What do the lights do when you select the 2811 protocol? Do they flicker and act erratic?


Reply
Posts: 4
 Ibid
Topic starter
(@ibid)
Active Member
Joined: 12 years ago

Oooh! How do I adjust the baud rate?


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

On your controller. WS2811 can run at either 400Kbps or 800Kbps.

Martin


Reply
Page 1 / 2
Share: