Activity
 
Notifications
Clear all
rednelb
@rednelb
Estimable Member
Joined: Dec 31, 2013
Topics: 10 / Replies: 81
Reply
RE: pixels going crazy with no signal

How doe the pixels react with a test pattern? How about the refresh rate on the E682? What firmware?

9 years ago
Reply
RE: Issue with e682, vixen 3 and ge color effects

My little trick for my GECEs if they give me issues addressing on power up is to run a test sequence on the E682.... Then I just unplug and plug in t...

9 years ago
Reply
RE: A yearly reminder for making power cords

Good to know. How did the fuses blow? It seems with the pictured plug that you would have an open circuit. Unless there was a path to ground or I am...

9 years ago
Reply
RE: SanDevices version 5 firmware information thread

My GECEs work fine with the new firmware. You still have to get the power up sequence right to get the addressing to be right. I was hesitant at fir...

9 years ago
Reply
RE: A yearly reminder for making power cords

Can't you pull one prong out and flip it around and ram in back in there?

9 years ago
Reply
RE: C9 single lights wont work

A standard C9 incan string should be 2 wire only. Each light is usually a tightly snapped vampire fitting or sometimes a molded fitting. In either...

9 years ago
Reply
RE: Where are you??

I love my incans!!! Had to add pixels because I had them and they are fun. I try and keep it looking classy with some color mixed in. This is las...

9 years ago
Forum
Reply
9 years ago
Forum
Reply
RE: Sandevice seems to be in testmode

Did you leave it in test mode? Is the port configured correctly for the pixels plugged into it? Did you leave something running on the network that ...

9 years ago
Reply
RE: Replace Incans or Add pixels???

I'm not adding any songs. So I can work on the additional pixels as the season goes. They are just straight lines. Easy to add to my show. I gues...

9 years ago
Topic
Replies: 3
Views: 2920
Reply
RE: GE Color effects expanded line

So, without digging around too much in this thread and forum.... ARE the 100 ct. GECE controllable or not? I am sitting on plenty of last years 36 ct...

10 years ago
Reply
RE: Putting Christmas lights up around the garage doors

test a small area with hot glue. most pvc and siding will not be affected when removed. typically lights stay in place all winter and glue comes off...

10 years ago
Forum
Reply
RE: Elements being skipped in sequencer

Thanks.... I figured that part out, and now If I drag an effect onto the elements in the group, they are the same color. However, now when I drag an ...

10 years ago
Reply
RE: Elements being skipped in sequencer

Ok.... So You are correct the color was different for that element. Now.... How do I fix this? Sorry I am new to vixen. Current LOR user and I am ...

10 years ago
Page 1 / 7
Share: