Notifications
Clear all

E682 issues

33 Posts
9 Users
0 Reactions
10.7 K Views
ebrady
Posts: 670
Topic starter
(@ebrady)
Prominent Member
Joined: 17 years ago
[#33487]

I am experiencing 2 E682 issues that I hope someone can help me with.

#1 - My E682 controller has a difficult time showing the configuration web page correctly. The page frequently is missing items at the bottom of the page, or has raw HTML content mixed into it. If I press refresh on my browser enough times, I can get a complete webpage, but I shouldn't have to do this.

#2 - I frequently have GECE pixels that stick on. This happens right at power up, and will not go away until power is cycled. When I recycle power to the E682 the pixels that are stuck on may change or go away completely. I have yet to see an instance where this occurs in any output other than 13,14,15 and 16 (Group 4). To troubleshoot, I powered down the controller and swapped a string with stuck pixels to an output that has never exhibited the problem and cycled power, the problem did not follow the string to the new output, but instead stayed with the "bad" output. This tells me I can rule out wiring and the string itself being bad.

This problem is not necessarily a show stopper for me as the strings that exhibit this problem are more towards the back of the tree, but it will require me to implement some means of turning the power on and off to the E682 at the beginning and end of the show.

Has anyone experienced either of these, and if so, what did you do to fix it?

Ed


32 Replies
Posts: 295
(@daytimer)
Reputable Member
Joined: 15 years ago

1. Have you tried a different browser? I've never had a problem. Are you running more than one network card in your computer? Is there something else on your network that might have the same ip address?
2. Did you build it as a kit, or buy it built? Sounds like you could have a solder bridge somewhere. Might want to check your solder joints if you built it.


Reply
ebrady
Posts: 670
Topic starter
(@ebrady)
Prominent Member
Joined: 17 years ago

Thanks for the reply - See below

1. Have you tried a different browser?

Yes - IE and Chrome

Are you running more than one network card in your computer? Is there something else on your network that might have the same ip address?

No and No

2. Did you build it as a kit, or buy it built? Sounds like you could have a solder bridge somewhere. Might want to check your solder joints if you built it.

Built as Kit, have already double checked for solder joints.


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Tried a different patch cable ?

Have you tried directly connecting to your nic ?

Updated firmware ?


Reply
ebrady
Posts: 670
Topic starter
(@ebrady)
Prominent Member
Joined: 17 years ago
angus40 wrote:Tried a different patch cable ?

Have you tried directly connecting to your nic ?

Updated firmware ?

I have tried a different patch cable, same results.

I have not tried a direct connection to the NIC (need to find a cross over cable), or updating the firmware, I will take a look at both.

Thanks
Ed


Reply
Page 1 / 7
Share: