pmiller wrote:Seems your setup is wrong.
First output: Start universe 1, Channel 1, End universe 6 channel 42
Second output: Start universe 6, channel 43, end universe 11 channel 84
Third output: Start universe 11, channel 85, end universe 12 channel 474If you want zig zag click the appropriate box on the right where it says first zig and then tell it how many after that to zag. Example. I have a 8 strings of 100 but I have 50 going up and 50 going down. I set the first zig to 50 and then every 50 after that. Make sure you hit save whenever you make a change.
Thank you
That worked for the first 2 outputs, but for some reason output on 3-1 doesn't light up
Also when i run the test on it, they are not synced, and can't keep up with each other
Btw, need a pic of your controller configuration setting. The universes need to be setup correctly.
Sent from my SM-T710 using Tapatalk
Your configuration setup should be like this:
Start 1 universe 1 size 510
Start 511 universe 2 size 510
Start 1021 universe 3 size 510
Start 1531 universe 4 size 510
Start 2041 universe 5 size 510
Start 2551 universe 6 size 510
Start 3061 universe 7 size 510
Start 3571 universe 8 size 510
Start 4081 universe 9 size 510
Start 4591 universe 10 size 510
Start 5101 universe 11 size 510
Start 5611 universe 12 size 473
Sent from my SM-T710 using Tapatalk
pmiller wrote:Your configuration setup should be like this:
Start 1 universe 1 size 510
Start 511 universe 2 size 510
Start 1021 universe 3 size 510
Start 1531 universe 4 size 510
Start 2041 universe 5 size 510
Start 2551 universe 6 size 510
Start 3061 universe 7 size 510
Start 3571 universe 8 size 510
Start 4081 universe 9 size 510
Start 4591 universe 10 size 510
Start 5101 universe 11 size 510
Start 5611 universe 12 size 473Sent from my SM-T710 using Tapatalk
That is it. Looks like there is something wrong with my controller. the 3 and 4 outputs are not sending data to the pixels.
Switch the outputs and then try again. If 3-1 3-4 aren't working try 4-1 4-4. Also, you may want to update the controller firmware. You can control each of the 16 outputs individually. You can also set the channel size to 510.
Sent from my SM-T710 using Tapatalk
