1.31 Bridge questio...
 
Notifications
Clear all

1.31 Bridge question

5 Posts
4 Users
0 Reactions
2,681 Views
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
[#42613]

When I first setup the bridge I ran the test mode on the configuration page and the lights did just fine. They burned steadily. Today I ran the test mode and the lights are flashing on and off really fast. Any idea what's causing this?


4 Replies
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

I just noticed something. I've been sequencing and doing live tests. Now when I go to the 1.31 configuration page and run the test mode the lights burn steadily. Strange.


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

Can't have 2 sources of data operating at the same time, even if you are not running a sequence it is still sending all off to the lights


Reply
Posts: 911
(@madsci1016)
Noble Member
Joined: 12 years ago

Don't have your sequencer (Vixen, xlights, FPP etc) open and running when using test mode.

Sent from my Nexus 5X using Tapatalk


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

To be more specific, you can't have two sources sending at the same time. Until programming is changed, use only one at a time. (There is the possibility of priority connections - but that is for the future.)

Your test mode on the controller board does count as one source.

xLights sending can be turned off by clearning (unchecking) the "Output to Lights" selection, or in the sequencer turning off the "light bulb".

Vixen sending can be turned off by setting the controllers to "stop". You can tell if it is off by looking at the dot to the left of the controller name. If a red circle, it is not sending to that controller.

I turn the controllers off in Vixen and then open a copy of xLights at the same time. (It is nice to have multiple screens.) I then turn on which one I want to see on the actual lights.


Reply
Share: