Notifications
Clear all

E682 help

29 Posts
5 Users
0 Reactions
6,519 Views
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Try this. There are 4 IC's(5-8) in front of each of the 4 outputs. Switch the IC's around. Put 5-6 where 7-8 are and 7-8 where 5-6 are. Make sure the pins are in and not bent. The one thing I didn't like about the 682 is soldering the other IC's to the board. I went to radio shack and bought sockets for all the IC's Malinga removal a snap.

Sent from my SM-T710 using Tapatalk


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Stupid auto typing. I have no idea what Malinga is. The word should have been making.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

Can you provide screenshots of your current Controller setup page and the controller setup in Vixen (hit the gear to bring up the configuration in Vixen). Sounds like you still have something not setup right.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

I got a board from someone and 1 port wasnt lighting I checked the solder and found 1 spot he missed hit it with my gun and solder and bang it lite up


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Taz, wonder if he got it working. No posts by him yet.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 15
Topic starter
(@rbf351)
Eminent Member
Joined: 11 years ago

All of the solder points look good, but it's possible something is missing since all 8 of them are not working. Guessing there is 1 solder point that i must have missed


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

Give Jim a call at Sandevices.


Reply
Posts: 15
Topic starter
(@rbf351)
Eminent Member
Joined: 11 years ago

ended up being my solder job that was the issue, but looks as if i will need a 2nd controller for the last strip of LEDs to work


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago

You can get a 6804 which is 40 bucks cheaper than another 682. I run a 800 pixel megatree with a 682 and a 90 pixel star with a 6804. I could have run the star off the 682 but I wanted to get maximum voltage to the megatree so I'm using all 16 outputs running 50 pixels each off 2 power supplies.

Sent from my SM-T710 using Tapatalk


Reply
Page 3 / 3
Share: