DIY Pixel Controlle...
 
Notifications
Clear all

DIY Pixel Controller

11 Posts
10 Users
0 Reactions
8,272 Views
Posts: 29
Topic starter
(@caffeinejunky)
Eminent Member
Joined: 9 years ago
[#53041]

First, "Don't wait until November" - yeah I'm an idiot and yet here I am.

Alright y'all. I feel like I've scoured the net pretty well. But not finding the semi-professional solution I'm looking for.

I'm going to be adding leaping arches and a snowflake prop this year to what has been a show that only has used an SSR based controller (Handbuilt of course - arduino based)

I've settled on prop design etc, but the controller part is what's killing me. When looking for SSR based controller designs I found a ton of idea. For DIY Pixel Controllers I'm finding much less.

So here's what I'm considering:
Arduino Based
Using Ethernet shield and E1.31 (sACN)
Pros:
Cheapish $15-25 with shield depending on nano/shield combo
Compact and so can more easily be waterproofed
Have a few examples of implementations
Cons:
Limited Memory (supports maybe 240 pixels?)

Raspberry Pi Based
Pros:
Much more memory, probably can support more
Can be remotely accessed via network
Cons:
Slightly More expensive $30ish but built in ethernet
Can't find examples

So can anyone point me to some semi-professional (Not an absolute hack job) examples of either? I'm using Vixen, but because I'm using E1.31, it shouldn't matter. Maybe there's something that I'm just not aware of.


10 Replies
ShadowLight8
Posts: 233
(@shadowlight8)
Reputable Member
Joined: 10 years ago

Take a look at pjrc.com for the Teensy boards and the OctoWS2811 adapter. They are arduino compatible, but able to run a lot more pixels. I've been them for 4 years and have had good results.


Reply
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago

Raspberry Pi - install FPP and you have everything up and running and able to run two strings of pixels of over 700 pixels each (at 40fps). More if you go slower. If the pixels are close to the Pi, you can likely wire the data line directly to the GPIO pin. Otherwise you would need a 5v buffer chip to increase the GPIO from 3.3v to 5v. Next up the ladder would be a Beaglebone. WAY WAY WAY more pixels (up to 48 strings of 800 at 40fps).


Reply
Posts: 1267
(@xmasinvancouver)
Noble Member
Joined: 10 years ago

Ummm here's a thought: wemos d1 mini... About $3 a pop. Up to 680 pixels per board. No joke. I am using a bunch of them. No need for a pi or a special board on short notice


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

check out this older thread about Arduino controlled pixels - http://doityourselfchristmas.com/forums/showthread.php?41730-Arduino-powered-show!&highlight=arduino+pixels+vixen

search for ESPixelstick for a wifi pixel controller that is inexpensive. There are many similar products to the ESPixelstick including this DIY example - http://doityourselfchristmas.com/forums/showthread.php?54755-ESP-D1-Mini-Motherboard


Reply
Page 1 / 3
Share: