DIY Pixel Controlle...
 
Notifications
Clear all

DIY Pixel Controller

11 Posts
10 Users
0 Reactions
8,273 Views
Posts: 13
(@shoopity)
Active Member
Joined: 10 years ago
Bgordon81 wrote:Can you post a screenshot of your network setup in WLED and your controller setup in Vixen? I can get the lights working with the app or through the web browser in WLED but I cannot get them to work with Vixen. I had this setup last year running and it worked fine. I did flash to the newest firmware which may have caused a hiccup.

I'll try to get a screenshot soon, but I don't use Vixen to run the show, I use FPP on the Pi Zero. Although I did run from Vixen for testing purposes.
I've got a USB ethernet hub (sort of like this) that I connect to a $5 wireless router I found at Goodwill.
I've got a USB Sound card that connects to the aforementioned hub (like this). That connects to an FM transmitter (thatlooks just like this, but it's a Signstek brand and I coulda sworn I got it for $35 three years ago).
So the Pi Zero is hard wired to the router.
My entire show only has 5 candy canes that I made with Pex pipe and 60/m WS2812B strips, so there's only 300 lights (900 channels).
In FPP I just have 2 universes defined.
Because it's a small 1 controller show (currently), and because my router is crappy at multicasting (it does it, but the controller misses more packets than it picks up), I'm broadcasting directly to the IP address of the DigUno.
In WLED, I'm connected to the same wifi router that the Pi is hardwired into. I also am using a static IP (since I'm not multicasting).
In the sync options of WLED I just turned on E1.31 and told it to start listening on Universe 1.
As long as the show runner (Vixen, FPP, whatever) and the "controller" running WLED are connected to the same network, it should work.


Reply
Page 3 / 3
Share: