Diff Controller/Sma...
 
Notifications
Clear all

Diff Controller/Smart Rx question

9 Posts
4 Users
0 Reactions
3,067 Views
Posts: 31
(@kiknads)
Eminent Member
Joined: 7 years ago

I've only got experience with the kulp boards so I cant attest to what the falcon's do. I've done most of the setup with the xlights visualizer and I dont remember seeing a slider at all in the fpp UI


Reply
Posts: 94
(@srmorgan)
Estimable Member
Joined: 7 years ago

I think that if you use falcon F48 you are able to control the allocation for each port between the different diff. receivers. The max is still the same.


Reply
Posts: 94
(@srmorgan)
Estimable Member
Joined: 7 years ago

I think that if you use falcon F48 you are able to control the allocation for each port between the different diff. receivers. The max is still the same.


Reply
Posts: 242
(@rsegreto)
Reputable Member
Joined: 6 years ago
kiknads wrote:most of the kulp boards have differential outputs, you can put any number of pixels per smart receiver as long as the group doesn't go over the max. Dont be scared of power injection

Not to hijack, can you explain this a little more? So I know from the K8 I can run up to 3 smart differential boards off of each RJ45 output if they are daisychained. The local ports can support up to 800 pixels so does this mean that any of the 3 RJ45 ports can only support 800 pixels as well? That would be split amongst however many differential receivers are daisy chained off of that RJ45 port?

Thanks,
-Russ


Reply
Page 2 / 2
Share: