Diff Controller/Sma...
 
Notifications
Clear all

Diff Controller/Smart Rx question

9 Posts
4 Users
0 Reactions
3,066 Views
Posts: 447
Topic starter
(@glycerine)
Honorable Member
Joined: 7 years ago
[#53939]

I am aware of how the falcon smart receivers work. I know that you can split the max pixels for each given port between them to maximize pixel usage and decrease power injection. What I have a question about is can you change the max pixels per port on ALL differential controllers that run FPP or only the Falcon F48? I guess the only other diff controllers that I know of are the Kulp F40D-PB and the PB16 that Scott Hansen created. Can those be configured the same way that the Falcon can in regards to smart receivers?


8 Replies
Posts: 31
(@kiknads)
Eminent Member
Joined: 7 years ago

most of the kulp boards have differential outputs, you can put any number of pixels per smart receiver as long as the group doesn't go over the max. Dont be scared of power injection


Reply
Posts: 447
Topic starter
(@glycerine)
Honorable Member
Joined: 7 years ago

Thank you. I know you can adjust that max on the falcon, can you also do it on kulp and other controllers?


Reply
Posts: 31
(@kiknads)
Eminent Member
Joined: 7 years ago

I mean the max per port is the max per port, just dont go over and it'll adjust itself


Reply
Posts: 447
Topic starter
(@glycerine)
Honorable Member
Joined: 7 years ago

I thought I remembered seeing something about being able to change the max pixels per port, but I found the video again and it's on the falcon F-16 with an expansion. You can adjust the max pixel support between the main board and the expansion.
See this video, around 6:25


Reply
Page 1 / 2
Share: