Notifications
Clear all

Dead Pixels?

6 Posts
5 Users
0 Reactions
2,053 Views
Posts: 326
Topic starter
(@jsheehan3)
Honorable Member
Joined: 17 years ago
[#40485]

About 2/3 through the season one of my 2811 strings from DIYLED stopped working at about the 35th pixel, the 34th pixel was stuck on full white and 1-33 continued to work as normal. I am preparing to taking things down and wanted to ask if that usually means 34-50 are all dead or whether to cut out 34 and reconnect? I am gonna play around with them to see if I can find a root cause but figured I'd toss out a question to see how others have faired since I know pixels occasionally go bad. Overall, I don't think it was too bad that out of 24 50 node strings I lost 16 pixels


5 Replies
Posts: 297
(@emkllk)
Reputable Member
Joined: 15 years ago

I usually do 'pixel surgery' when that happens and replace where the one that's not working. However it's not an exact science as sometimes the problem can be with the outgoing part of the last working pixel. There's probably better ways to test but during show season if I can't juggle it out, I cut and add a new pixel. I would doubt that all of the remaining pixels are dead.

Sent from my iPhone using Tapatalk


Reply
Posts: 464
(@holtm)
Honorable Member
Joined: 19 years ago

It likely either #33 (not sending data) or #34 (not using/send on the data correctly). The rest of the string are likely still good.


Reply
bcstuff
Posts: 449
(@bcstuff)
Reputable Member
Joined: 16 years ago

Too many times I cut one and it is the other, Now I cut the last working pixel and the first not working pixel out and replace both. In the whole scheme of things the time vs price just isn't worth my screwing with it.

Every once and a while I can see what is causing the problem like exposed or broken wires and I just replace one. :thup2:


Reply
Posts: 326
Topic starter
(@jsheehan3)
Honorable Member
Joined: 17 years ago

Thanks guys. Guess you can have some ugly "Frankenstein" strings of you do this often (fingers crossed).

Got a similar problems with the 3 LED rectangle pixel modules. Some don't light at all while some only light for certain colors. Thought it might have been rain messing with exposed wires going into epoxy but it must be something with the onboard ic

Sent from my iPhone using Tapatalk


Reply
Posts: 123
(@tonyhight)
Estimable Member
Joined: 12 years ago
bcstuff wrote:Too many times I cut one and it is the other, Now I cut the last working pixel and the first not working pixel out and replace both. In the whole scheme of things the time vs price just isn't worth my screwing with it.

Every once and a while I can see what is causing the problem like exposed or broken wires and I just replace one. :thup2:

That's what I do as well 1 good pixel tossed tossed is much better than finding g out after your done that the bad pixel wasn't the one to thought.

--Tony Hight
http://www.hightfantasylights.com


Reply
Share: