holtm
@holtm
Honorable Member
Joined: May 29, 2007
Last seen: Nov 17, 2026
Topics: 47 / Replies: 417
Reply
RE: Soffit mount

Looks like TrimLight

5 years ago
Forum
Reply
RE: FS 325 DIYLEDExpress PixaBulb 12v

Here are three photos. The two on the blue background (kidie pool) are in direct sunlight. The one with the hand is in the shade. I hadn't noticed the...

5 years ago
Topic
Replies: 4
Views: 1683
Reply
RE: Permanant Christmas Light Mounting Track

they are pre order and with holds, but here's a site: This video shows him installing them:

6 years ago
Reply
RE: New guy, the story so far and considerations for next year.

I live in the mouth of a canyon and have to tie things down really well. Right on the house not so much, but my yard stuff requires some long rebar st...

6 years ago
Reply
RE: Issue w/ DIYLedExpress Bridge and FPP

Try to replace the power supply for the bridge? It may read 5v, but may have enough ripple to cause the ethernet module to not work correctly.

6 years ago
Reply
RE: Layers?

Found it. It's no longer in the right click dropdown -- it's a tab on the right now. (Once a second layer is created it shows on the context menu).

6 years ago
Topic
6 years ago
Replies: 1
Views: 1385
Reply
RE: Help, Problem with LED flashing

RobG's "Buffer/line driver - null pixel without pixel "work really well as a level shifter on these boards. If you don't have one

6 years ago
Forum
Reply
RE: LRS-350 Meanwell power supply

You've likely already done this: Check the input voltage switch is in the right position. Check the fuse. Otherwise you may have a dead unit.

6 years ago
Reply
RE: Want to throw in the towel

Try a different port on the E1.31. I had a 1 of the 6 ports go bad on one of my three, it was a bad pin on the parallax micro processor.

8 years ago
Reply
RE: e1.31 bridge boots into test mode

Thanks for the tip, I'll check that. I'll try to figure out how to secure it when I can bring it inside in January.

8 years ago
Reply
RE: e1.31 bridge boots into test mode

Update: tonight is started doing it in the middle of the show so it's not just at boot. There's a lot of snow out there now, but I might have to re-fl...

8 years ago
Reply
RE: e1.31 bridge boots into test mode

The IP is good, the setup is good, I just need to go the the setup web page, change the pick list from Red to Off and click the Change Test Mode butto...

8 years ago
Page 1 / 31