MrSmoofy wrote:I've not tried it myself I have everything to put it together to test other then time 🙂 Can you describe how you have it all wired up pictures would be good too. I'll try to get one assembled this weekend and give it a try to see what luck I have.
I sent picture to Rob and he said everything looked good but was not sure if that controller would work as the pixels are 2811 (FAST). I get white light but if I switch to 2801 I get blue and white alternating on the built in sequences..
Are yours the 10w or 20w ones? I didn't realize that they were 2811 (FAST) and thought this would work. It only supports the following according to the Holidaycoro website
Signal (SPI)/Pixel output:
Pixel protocols
2801 / WS2801 (4 wire)
2811 / WS2811 (3 wire)
6803 (4 wire) & LPD6803, LPD1101, D705, UCS6909, UCS6912
TM1803, TM1804, TM1809,TM1812, UCS1903, UCS1909, UCS1912, UCS2903, UCS2909, UCS2912, WS2811
3001 (3 wire) & TLS3001, TLS3002
GECE pixel support will not be provided in this unit
I have the 10 watt ones. I sent an email to holiday coro a few days ago to confirm but they have not responded..
ronaldpa2 wrote:I have the 10 watt ones. I sent an email to holiday coro a few days ago to confirm but they have not responded..
I have the 20W I'll try to give it a go this weekend and let you know.
lightaholic wrote:If you are looking for a good controller look at the 8 universe controller over at Ron's Holiday Lights. He has a website but most of his business is handled at DIYChristmas.org. I have 2 8s plus his new 16 universe controllers.Steve aka llightaholic
+1 on Ron's Holiday Lights controllers. I have a 16 Univ controller running 8 univ of 5V pixels, 1 univ of 12V pixels, and outputing Renard to run 256 channels, and still have a lot of capacity left!
Renard PX1 is good if your on a budget
I have 4 now and couldn't fault them,
MrSmoofy wrote:I have the 20W I'll try to give it a go this weekend and let you know.
I built another one and its working but I think it may have shorted out when I put it in the flood case? Are you putting anything behind the board so it does not touch the metal ?



