Got a string of Pixastrings from DIYLED to test to see if Ill like them for use in my bushes for next year (2016). Can't seem to find anything about which wire is which and since you can't see the node makes it more difficult.
http://www.diyledexpress.com/index.php?main_page=product_info&cPath=42_59&products_id=345
I thought it would be like the Pixabulbs but this string didn't even have the pigtail on it like the pixabulbs do, just the bare connector on each end. Any tips/ideas would be helpful, I did email Todd just waiting to hear back.
I don't have the pixa strings, but can you take the back cover off the node like you can on the pixa bulbs? Should say on the board which is gnd, VCC, Data.
Rob
Nope can't take the green off, its filled with the expoxy. You can take the lens off but that only shows the led lens. Can't see the board itself. I thought maybe it was like the pixabulbs, VCC,Data,GND but nope.
tjetzer wrote:Here is the pinout.
Thanks Todd
Has any one else noticed that the GND and VCC are rolled on these compared to the Pixabulb? I tried to connect a string to the output of the pixabulbs and luckily didn't fry anything.
Yep I noticed that, I had a controller already setup for pixabulbs and when I got nothing I shutoff quick and why i asked here. Lucky I didn't fry anything also.
So it wasn't just me seeing/believing it was different.
In planning for next year, what's the difference between the Pixabulbs and Pixastrings? I'd like to replace my sidewalk C7 AC strings with pixels. They are on stakes so I'm guessing PixelStrings is what I'd want?

